Makita XSF04R Makita XSF05T Instruction Manual - Page 8

1 Hook 2 3 Fig.12 ► 1 . Locator 2. Bit 3. Magnetic bit holder To remove the driver bit, pull the locator, and then grasp the bit with a pair of pliers and pull the bit out of the magnetic bit holder. To install the driver bit, push it firmly into the magnetic bit holder. Then install the locator by pushing it firmly back. For XSF05 1 2 3 1 2 3 Fig.15 ► 1 . Groove 2. Hook 3. Screw The hook is convenient for temporarily hanging the tool. This can be installed on either side of the tool. To install the hook, insert it into a groove in the tool housing on either side and then secure it with a screw. To remove, loosen the screw and then take it out. OPERATION Screwdriving operation Fig.13 1 ► 1 . Locator 1 2 Fig.14 ► 1 . Locator 2. Socket bit To remove the socket bit, pull the locator, and then pull the socket bit. To install the socket bit, push it firmly into the sleeve. Then install the locator by pushing it firmly back. Fig.16 Fit the screw on the point of the bit and place the point of the screw on the surface of the workpiece to be fastened. Apply pressure to the tool and start it. Withdraw the tool as soon as the clutch cuts in. Then release the switch trigger. CAUTION: When fitting the screw onto the point of the bit, be careful not to push in on the screw. If the screw is pushed in, the clutch will engage and the screw will rotate suddenly. This could damage a workpiece or cause an injury. CAUTION: Make sure that the bit is inserted straight in the screw head, or the screw and/or bit may be damaged. 8 ENGLISH