Makita XSS03Z XSS03Z Instruction Manual - Page 8
Battery protection system, Lithium-ion battery with star marking, Adjusting depth of cut, Bevel
View all Makita XSS03Z manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
Battery protection system (Lithium-ion battery with star marking) 1 1. Star marking Bevel cutting 1. Lever 1 012128 Lithium-ion batteries with a star marking are equipped with a protection system. This system automatically cuts off power to the tool to extend battery life. The tool will automatically stop during operation if the tool and/or battery are placed under one of the following conditions: • Overloaded: The tool is operated in a manner that causes it to draw an abnormally high current. In this situation, release the switch trigger on the tool and stop the application that caused the tool to become overloaded. Then pull the switch trigger again to restart. If the tool does not start, the battery is overheated. In this situation, let the battery cool before pulling the switch trigger again. • Low battery voltage: The remaining battery capacity is too low and the tool will not operate. In this situation, remove and recharge the battery. Adjusting depth of cut 1. Lever 007971 Loosen the lever on the bebel scale plate on the front base. Set for the desired angle (0° - 50°) by tilting accordingly, then tighten the lever securely. Sighting 1. Base 2. Cutting line 1 A2 B 007972 For straight cuts, align the A position on the front of the base with your cutting line. For 45° bevel cuts, align the B position with it. Switch action 1 2 1. Lock-off lever 2. Switch trigger 1 007970 CAUTION: • After adjusting the depth of cut, always tighten the lever securely. Loosen the lever on the side of the rear handle and move the base up or down. At the desired depth of cut, secure the base by tightening the lever. For cleaner, safer cuts, set cut depth so that no more than one blade tooth projects below workpiece. Using proper cut depth helps to reduce potential for dangerous KICKBACKS which can cause personal injury. 008050 CAUTION: • Before inserting the battery cartridge into the tool, always check to see that the switch trigger actuates properly and returns to the "OFF" position when released. • Do not pull the switch trigger hard without pressing the lock-off lever. This can cause switch breakage. To prevent the switch trigger from being accidentally pulled, a lock-off lever is provided. To start the tool, press the lock-off lever and pull the switch trigger. Release the switch trigger to stop. WARNING: • For your safety, this tool is equipped with lock-off lever which prevents the tool from unintended 8