Makita XT1500 Owners Manual - Page 8

1 1. Rear cover 2. Screws 2 To maintain product SAFETY and RELIABILITY, repairs, any other maintenance or adjustment should be performed by Makita Authorized or Factory Service Centers, always using Makita replacement parts. OPTIONAL ACCESSORIES 007458 Raise the arm part of the spring and then place it in the recessed part of the housing with a slotted bit screwdriver of slender shaft or the like. 1 1. Spring 2. Arm 3. Recessed part 3 2 007459 Use pliers to remove the carbon brush caps of the carbon brushes. Take out the worn carbon brushes, insert the new ones and replace the carbon brush caps in reverse. 1. Carbon brush cap CAUTION: • These accessories or attachments are recommended for use with your Makita tool specified in this manual. The use of any other accessories or attachments might present a risk of injury to persons. Only use accessory or attachment for its stated purpose. If you need any assistance for more details regarding these accessories, ask your local Makita Service Center. • Sockets • Extension bar • Universal joint • Bit adapter • Various type of Makita genuine batteries and chargers NOTE: • Some items in the list may be included in the tool package as standard accessories. They may differ from country to country. 1 007460 Make sure that the carbon brush caps have fit into the holes in brush holders securely. 1 1. Hole 2. Carbon brush cap 2 006304 Reinstall the rear cover and tighten two screws securely. After replacing brushes, insert the battery cartridge into the tool and break in brushes by running tool with no load for about 1 minute. Then check the tool while running and electric brake operation when releasing the switch trigger. If electric brake is not working well, ask your local Makita service center for repair. 8