Makita XT281S XDT13 Instruction Manual - Page 6
Assembly
View all Makita XT281S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
Lighting up the front lamp ASSEMBLY CAUTION: Always be sure that the tool is switched off and the battery cartridge is removed before carrying out any work on the tool. Installing or removing driver bit/ socket bit 1 ► 1 . Lamp 12 mm (15/32") 9 mm (3/8") CAUTION: Do not look in the light or see the source of light directly. Pull the switch trigger to light up the lamp. The lamp keeps on lighting while the switch trigger is being pulled. The lamp goes out approximately 10 seconds after releasing the switch trigger. NOTE: Use a dry cloth to wipe the dirt off the lens of the lamp. Be careful not to scratch the lens of lamp, or it may lower the illumination. Reversing switch action Use only the driver bit/socket bit shown in the figure. Do not use any other driver bit/socket bit. 1 2 A 1 ► 1 . Reversing switch lever ► 1 . Driver bit 2. Sleeve B To install the driver bit, insert it into the sleeve as far as it will go. CAUTION: Always check the direction of rotation before operation. CAUTION: Use the reversing switch only after the tool comes to a complete stop. Changing the direction of rotation before the tool stops may damage the tool. CAUTION: When not operating the tool, always set the reversing switch lever to the neutral position. This tool has a reversing switch to change the direction of rotation. Depress the reversing switch lever from the A side for clockwise rotation or from the B side for counterclockwise rotation. When the reversing switch lever is in the neutral position, the switch trigger cannot be pulled. 1 2 ► 1 . Driver bit 2. Sleeve To remove the driver bit, pull the sleeve in the direction of the arrow and pull the driver bit out. 6 ENGLISH