Makita XWT08Z XWT07/XWT08/XWT09 Instruction Manual - Page 9
Operation
View all Makita XWT08Z manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Installing or removing drill bit/ socket adapter Only for Model XWT09 (optional accessory) Ring Only for Model XWT09 2 1 A 3 A=11.2 mm (7/16″) Use only the drill bit/socket adapter shown in the figure. Do not use any other drill bit/socket adapter. 1 ► 1 . Bracket 2. Ring 3. Screws The ring is convenient for hanging the tool with hoist. First, place the rope through the ring. Then hang the tool up to the air with hoist. CAUTION: Before using the ring, always make sure that the bracket and ring are secured and not damaged. Installing hook 2 ► 1 . Drill bit 2. Sleeve To install the drill bit, pull the sleeve in the direction of the arrow and insert the drill bit into the sleeve as far as it will go. Then release the sleeve to secure the drill bit. To remove the drill bit, pull the sleeve in the direction of the arrow and pull the drill bit out. NOTE: If the drill bit is not inserted deep enough into the sleeve, the sleeve will not return to its original position and the drill bit will not be secured. In this case, try re-inserting the drill bit according to the instructions above. NOTE: After inserting the drill bit, make sure that it is firmly secured. If it comes out, do not use it. 1 3 2 ► 1 . Groove 2. Hook 3. Screw The hook is convenient for temporarily hanging the tool. This can be installed on either side of the tool. To install the hook, insert it into a groove in the tool housing on either side and then secure it with two screws. To remove, loosen the screws and then take it out. OPERATION CAUTION: Always insert the battery cartridge all the way until it locks in place. If you can see the red part on the upper side of the button, it is not locked completely. Insert it fully until the red part cannot be seen. If not, it may accidentally fall out of the tool, causing injury to you or someone around you. 9 ENGLISH