Marantz DR4050 DR4050 USER'S MANUAL - Page 19

RECORDING English Manual recording from external CD player STOP CD RECORDER DR4050 REC TYPE REC FINALIZE ERASE SOURCE CD-R § MANUAL starts to flash and the display shows REC EXT MAN followed by WAIT. After a few seconds PRESS RECORD followed by the remaining time and track number appear on the display. REM REC TIME TRACK TOTAL REM TRACK TIME STEP EASY JOG - + STORE CANCEL PLAY/PAUSE STOP /MENU /DELETE PUSH ENTER PROG SHUFFLE DISPLAY SCROLL REPEAT DJ MODE Important: - Recording from CD-changers should always be started in the Auto-Start mode. - Only make analog recordings when digital recording is not possible. Preparing for manual recording 1 Make sure the disc is absolutely free of scratches and dust particles. 2 Press SOURCE repeatedly until (depending on the connection used): § DIGITAL I, OPTICAL I or ANALOG lights up and DIGITAL 1, OPTICAL or ANALOG appears on the display. REM REC TIME TRACK TOTAL REM TRACK TIME STEP SYNC MANUAL RECORD CHANGER PROG SHUFFLE ALL • When Auto Track is On (default setting), track numbers will automatically be increased during recording. • To switch off the Auto Track function you have to enter Menu mode. If you wish to increase track numbers manually, press TRACK INCR(ement) on the remote control. For further instructions see Menu mode. ON (Auto): The track increments are automatically taken over from the digital source material or after 2.7 seconds silence during analog recording. OFF (Manual): While recording track numbers can be incremented manually by pressing TRACK INCR(ement) on the remote control. (Minimum track length is 4 sec.) (This can also be done in Auto track ON mode.) • Track numbers cannot be changed after recording. Note: Auto track works only with Consumer Sources with a digital output signal according to the IEC 958 (consumer part) audio standard. 3 With the recorder stopped, press REC TYPE five times to enter the Manual Record standby mode. SYNC MANUAL RECORD CHANGER PROG SHUFFLE ALL 4 Play the source first to set the optimal recording level on the CD recorder. 5 Rotate the EASY JOG/ENTER key until, on the Record/Play Level bar, all the blue segments are alight, but the red segments do not light continuously during the loudest passages. § Display shows _XX DB (Decibel, e.g. -3DB). 6 Stop the source. Start manual recording 1 To start recording, press RECORD on the CD recorder and immediately start the source (from Pause or Stop-mode). § d lights continuously. The track number and recording time left appear on the display. • If CHECK INPUT message also flashes, the digital connection is incorrect. • To record a 3-second silence at the start of a track, press PAUSE on the CD recorder before starting the source. • To check the total remaining recording time, press DISPLAY on the CD recorder. (This can also be done during the recording.) 2 To stop recording, press STOP on the CD recorder. § UPDATE lights up and d goes out. • If STOP was pressed within 3 seconds after RECORD, no recording will take place. • To interrupt recording, press PAUSE on the CD recorder. d starts to flash. Press PAUSE again to restart recording. ( A new track will always be made.) After recording the display will show UPDATE for several seconds. Note: With AUTO TRACK ON, the recorder will stop and go to REC STANDBY for 1 minute and then goes to Stop mode automatically. Recordings from DAT, DCC or recordings made analogously will stop after 20 seconds silence. With AUTO TRACK OFF, the auto stop mode is disabled. Important: If you want to play the recorded CDR disc on any regular CD player, it must first be finalized. See finalizing discs. Finalized CDRW discs play only on CDRW compatible CD players. For recording from CD changers always use REC EXT 19