Marantz DV7001 DV7001 User Manual - Page 11

English Connecting Up Home theater video connections This player outputs video in a number of different ways. Choose the one most suitable for your system using the guide below. 1 If your TV has a component video input, we recommend using it to connect directly to the COMPONENT VIDEO OUT of this player. Use the standard 3-jack component video output. 2 Important • Before making or changing any rear panel connections, make sure that all components are switched off and unplugged from the wall outlet. • While a connected component is turned on, do not unplug the power cord of this DVD player from the wall outlet. The speaker may be damaged. If your TV has a SCART input, we recommend using it to connect directly to the A/V EURO CONNECTOR on this player. (for Europe only) OUT IN RS-232C FLASHER IN INT. EXT. REMOTE CONTROL HDMI Ver 1.1 SURR.R COAX. OPT. DIGITAL OUT SURR.L AUDIO OUT SUB WOOFER CENTER COMPONENT Y CB/PB CR/PR FRONT R L VIDEO S1 1 MIXED 2CH R L 2 VIDEO OUT A/V EUROCONNECTOR AC IN 3 If your TV and projector have a HDMI terminal for Video and Audio Input, we recommend using it to connect directly to the HDMI out of this player. 2 If a component input is not available to you, connect this player to your TV or AV receiver using either the VIDEO or S1 jacks. 4 Plug into a standard AC wall outlet. Connecting SCART (for Europe only) and S-Video cables SCART and S-Video cables will only plug in one way, so make sure the plug is correctly lined up with the jack before inserting. Be sure to fully insert for a good connection. Note • The A/V EURO CONNECTOR can output composite or RGB component video. If you connect just one TV, use the A/V EURO CONNECTOR. You can select the type of video output by changing the COMPONENT setting in the DVD Setup Menu (page 49). S-Video or composite video? S-Video should give a better picture, so if you have an S-Video input, use it. S-Video cables are available from any good audio/ visual dealer. Connecting HDMI cables With an HDMI cable, both uncompressed video data and digital audio data (e.g., LPCM or bit stream data such as Dolby Digital, DTS, MPEG data or DVD Audio Multi channel) can be transmitted with just a single connector. By transmitting DVD image data directly as digital data without it being first converted into analog format, it becomes possible to provide the very finest in image quality (see pages 6, 41, 42, 47). Note • The HDMI output of this unit can be connected to a DVI jack on a TV or other device using a conversion adapter. In this case, it is necessary to use a TV or display with an HDCP-compatible DVI input. • There may be no image output if connected to a TV or display that is not compatible with the above format. • Refer to the instruction manual of the TV or display to be connected to this unit for detailed information regarding the HDMI terminal. • When connecting a progressive input TV with the component output of the player, select ON in the Progressive setting (see page 45). 11