Marantz PMD371 User Guide - Page 32

English Troubleshooting If your unit should not perform as expected, consult the table below to see if the problem can be corrected before seeking help from your dealer or our service organization. Problem No power No play No sound Poor or distorted sound Sound skips Programming or deleting does not perform. "Error" is displayed. Possible Cause REMEDY • The AC input cord is disconnected. • The POWER switch is not pressed correctly. • Connect the cord securely. • Press the POWER button to ON. • The disc is loaded upside down. • Dirty disc. • Defective or deeply scratched disc. • Reload the disc with the printed side up. • Clean the disc. • Load another disc. • Incorrect connections. • Incorrect operation of the amplifier. • The " ; " indicator lights up. • Make connections correctly. • Operate the amplifier correctly. • Press the PLAY or PAUSE button to cancel the pause mode. • The unit is connected to the PHONO input jacks of the amplifier. • Poor connections. • Make connections correctly. • Check the connections and connect all cords securely. • Defective or deeply scratched disc. • This unit is placed on a surface that is subject to vibration or physical shock. • Play another disc. • Place this unit on a stable surface. • The disc is dirty or badly scratched. • The programming or deleting procedure is not correct. • The number of the programmed selections is 32. • Try again with a scratch-free disc. • Try again. • Check the number of the programmed selections. • Incorrect operation. • Press the OPEN/CLOSE button to open and close the disc tray or press the POWER switch to turn the power off and on. 28