Marantz SR4000 User Guide - Page 21

436 &OH
%'6 1.

ϖʔδ ENGLISH TUNER Tuning to radio stations You can search for radio stations by scanning the frequency band. You can also key in the frequency of a known radio station. If an FM station is being broadcast and received in stereo, STEREO is shown. Searching for radio stations 1 Turn INPUT SELECTOR to select the tuner. → is displayed. 2 Select a waveband by pressing BAND repeatedly. → The selected waveband is displayed. 3 Keep or pressed for approximately 1 second. → is displayed and the tuner tunes to a station with sufficient strength. 4 Repeat this procedure until you find the desired station. • To fine tune to a weak transmitter, briefly press or as often as necessary for optimum reception. Tuning to a radio station by frequency (with the remote control only) 1 Press TUNER. → is displayed. 2 Press TUNER again to select a different waveband. → The selected waveband is displayed. 3 Press FR. D.. → _ is displayed. 4 Use 1-0 to key in the frequency of a radio station. Note: Only valid numbers within the frequency range of the tuner can be keyed in. Switching FM sensitivity You can switch the tuner to a lower search sensitivity, to search for stations with a strong signal only (FM only). 1 Turn INPUT SELECTOR to select the tuner. → is displayed. 2 Press SENS. on the receiver. → Either SENS HI or SENS LO is displayed for 5 seconds. Note: While searching for radio stations, the actual sensitivity is displayed. In this case, SENS LO means the tuner is only looking for radio stations with a strong signal. Storing radio stations You may store up to 30 radio stations in the memory. The receiver can select and program radio stations by itself or you can choose them yourself. Automatic programming 1 Choose from the menu and press NEXT . 2 Choose and press NEXT . → The preset number where programming will start, the waveband and are displayed. 3 Turn TUNER PRESET to change the preset number where programming should start. 4 Use BAND to switch to the desired waveband. 5 Press ENTER / OK to start programming. → flashes and all available radio stations are programmed, this may take a few minutes. Programming is done when stops flashing. Manual programming 1 Choose from the menu and press NEXT . 2 Choose and press NEXT . → A preset number, the waveband and the frequency are displayed. 3 Turn TUNER PRESET to change to the preset number where the radio station should be stored. 4 Tune to the desired radio station (see "Searching for radio stations"). 5 Press ENTER / OK to confirm your selection. → is displayed briefly. The radio station is programmed at the chosen preset number. 6 Select and store all desired radio stations this way. 16