Maytag MDB7749AWM Installation Instructions - Page 18

Connect to Drain 1 Connect drain hose Green clamp Black drain hose connector Drain hose Stop Drain hose stop Stop Place towel under drain hose to catch any water in drain hose. Place the small green drain hose clamp onto the small end of the drain hose. Push the new drain hose into the black drain hose connector up to the drain hose stop. 2 Slide clamp onto connector Green clamp Black drain hose connector Stop Drain hose Drain hose stop Stop Using pliers, squeeze open the small green drain hose clamp and slide onto connector between stops. 3 Hose clamp final position Black drain hose connector Drain hose Green clamp Drain hose stop Stop Stop After hose is connected, remove towel. If needed, see website for animated representation of this step. Visit www.maytag.com/drain under FAQ tab. Make Direct Wire Electrical Connection NOTE: If the power supply cord was connected earlier proceed to "Secure Dishwasher in Cabinet Opening" section. Option B, Direct Wire: 1 Direct Wire-Route cable into terminal box Route cable so that it does not touch dishwasher motor or lower part of dishwasher tub. Pull cable through cable clamp in terminal box. Select UL listed or CSA approved twist-on wire connectors (not included) rated to connect your household wiring to 16-gauge dishwasher wiring. 18