Maytag MDB7749SBB Use & Care Guide - Page 7

CONTROLS AND CYCLE STATUS CONTROL PURPOSE COMMENTS To start or resume a wash cycle If the door is opened during a cycle or the power is interrupted, the START/RESUME indicator flashes. The cycle will not resume until the door is closed and START/RESUME is pressed. NOTE: If the START/RESUME button is located on top of door, push door firmly closed within 3 seconds of pressing START/RESUME. If the door is not closed within 3 seconds, the start button LED will flash, an audible tone will be heard, and the cycle will not start. To reset any cycle or options during selection. To cancel a wash cycle after it's started. Press CANCEL/DRAIN to reset any control selections made. See "Canceling A Cycle" and "Changing A Cycle After Dishwasher Is Started" sections. To turn the audible tones on or off. Press and hold the Hi Temp Wash button for 3 seconds to turn the audible tones on or off. Only audible tones for confirming button presses can be turned on/off. Important audible tones, such as indicating a cycle has been interrupted, cannot be deactivated. NOTE: Audible tones are not available on all models. Dishwasher Feedback Section CONTROLS AND CYCLE STATUS CONTROL PURPOSE COMMENTS The Cycle Status Indicator Lights are used to follow the progress of the dishwasher cycle. Located on the front of the dishwasher for front control models, and located on the top of the door for hidden control models. Clean indicator glows when a cycle is finished. If you select the Sani Rinse option, when the Sani Rinse cycle is finished, the Sanitized indicator glows. If your dishwasher did not properly sanitize your dishes, the light flashes at the end of the cycle. This can happen if the cycle is interrupted, or the water could not be heated to the required temperature. The Clean and Sanitized lights go off when you open and close the door or press CANCEL. Canceling A Cycle 1. Open the door slightly to stop the cycle. Wait for the spraying action to stop before completely opening the door. 2. Press CANCEL/DRAIN button once. The Cancel/Drain light will light up. 3. Close the door and the dishwasher starts a drain cycle (if water remains in bottom of dishwasher). Let the dishwasher drain completely. The Cancel/Drain light turns off after 2 minutes. Changing A Cycle After Dishwasher Is Started 1. You can interrupt a cycle and restart your dishwasher from the beginning using the following procedure. 2. Open the door slightly to stop the cycle. Wait for the spraying action to stop, then open the door completely. 3. Check that detergent dispenser cover is still closed. If cover is open, you will need to refill the detergent dispenser before restarting your new cycle. 4. Press CANCEL/DRAIN twice to reset the control. 5. Select new cycles and options. 6. Press START/RESUME. Adding A Dish After Dishwasher Is Started 1. Check if Add a Dish indicator is lit. (Available on some models. Otherwise, proceed to Step 2.) 2. Open the door slightly to stop the cycle. Wait for the spraying action to stop, then open the door completely. 3. Check whether the detergent dispenser cover is still closed. If it is open, the wash cycle has already started and adding a dish is not recommended. 4. If detergent has not yet been used (detergent dispenser cover is closed), you may add a dish. 5. Press START/RESUME. 7