Maytag MDB7759AWS Installation Instructions - Page 3

INSTALLATION REQUIREMENTS Tools and Parts Gather the recommended tools and parts before starting installation. Read and follow the instructions provided with any tools listed here. All Installations Tools needed: Pliers Flat-blade screwdriver Phillips screwdriver and ¹⁄₄" nut drivers or hex sockets Measuring tape or ruler 10" adjustable wrench that opens to 1¹⁄₈" (2.9 cm) Utility knife UL listed or CSA approved twist-on wire connectors* Small level ⁵⁄₈" open-end wrench Hammer Sand paper *Must be the proper size to connect your household wiring to 16-gauge wiring in dishwasher Other useful items you may need: Flashlight Bath towel Shallow pan Wood block Parts supplied: 2 - Drain hose clamps (1 large and 1 small) Drain hose 2 - #10 x ¹⁄₂" Phillips-head screws Silver Green Make sure all these parts are included in the literature package. Parts needed: Other parts you may also need: 1 ¹⁄₂" -2" (38.1-5.0 cm) Screw-typ e clamps (3 max) Masking or duct tape NOTE: Parts available for purchase in plumbing supply stores. Check local codes. Check existing electrical supply. See "Electrical Requirements" section. It is recommended that electrical connections be made by a licensed electrical installer. In addition, for first-time installations Tools needed: Cordless drill with and 1¹⁄₂ " hole saw bits Small tubing cutter Wire stripper Parts needed: Copper tubing O.D. suggested) or flexible braided water supply line See "Electrical Requirements" section For Direct Wire: use UL listed or CSA approved strain relief to fit 2.2 cm) hole For Power Supply Cord: use UL listed power supply cord kit Part Number 4317824 marked for use with dishwasher Additional parts supplied with certain models only: Bottom sound pad (located Moisture barrier tape in lower rack) Make sure all these parts are included in the package containing literature. 3