Maytag MDBH945AWB Use and Care Guide - Page 7

CvclesO, ptionasndLights Cycles Choose tile cycle that best describes your dishload by pressing the cycle select pad. (See page 3, Operating Tips, for how to begin the cycle). Heavy Normal Light Rinse Only (select models) Long cycle for heavy food soils. Medium cycle for average food soils. The turbidity sensor is active with this cycle. Short cycle for light food soils. Rinses dishes being held until there is a full load. 132" 97-117" 82* 9 2 washes/3 rinses 1-2 washes**/1-2 rinses *_ 1 wash/2 rinses 1 rinse Includes approximately 30 minutes of dry time. **Number of fills will vary depending on the soil level of each load. Notes • Depending on water temperature, there may be time added to the cycle to bring water up to temperature. • Only the following certified cycles have been designed to meet NSF requirements (NSF/ANSI 184 Residential Dishwasher) for sanitization: Heavy, Normal and Light cycles. Options In addition to choosing a cycle, choose as many available options as are needed for your dishload. Hi femp Wash Heated Dry Delay Tough ScrubTM/ Tough Scrub PlusTM ([select models) Sanitize ([select models) START/CANCEL Control Lock Option ([select models) Hi Temp Wash provides additional heat during the wash portion of the cycle, which ensures proper water temperature for better cleaning and drying results. It also adds an additional rinse to the cycle which improves results in hard water situations. For enhanced drying results select this option. When Heated Dry is not selected, towel drying of some items such as plastic and items with non-stick surfaces may be necessary and more moisture may be noticed adhering to the dishwasher interior. In models with plastic interiors, it is normal to notice vapor escaping from the door vent as the heat dries your dishes. Vapor will escape even if Heated Dry is not selected. Use to automatically start the cycle at a later time. See page 7 for instructions. Select when washing loads with hard to remove soils. Depending on which cycle is being used, this option adds heat, water and or wash time to the wash cycle. Sanitizes dishware. When cycle monitor recognizes that the proper conditions have been met, Sanitized light will activate at the end of the cycle. Sanitization may not be achieved if there is an interruption of the cycle, power failure or if the incoming water temperature is below 120° F [49 ° C]. Starts and stops dishwasher. See page 3 under Operating lips: Operating the Dishwasher, for explanation. Locks control touchpad to prevent unwanted use. See page 7 for instructions. All cycles (except Rinse Only [select models]) All cycles (except Rinse Only [select models]) All Cycles All Cycles All Cycles All Cycles All Cycles 6