Maytag MED5900TW Technical Education - Page 30
Connect Vent, Level Dryer
UPC - 883049041292
View all Maytag MED5900TW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
A combination of pipe fittings must be used to connect the dryer to the existing gas line. Shown is a recommended connection. The connection may be different, according to the supply line type, size and location. D D A A BB CC A. ³⁄8 " flexible gas connector B. ³⁄8 " dryer pipe C. ³⁄8 " to ³⁄8 " pipe elbow D. ³⁄8 " pipe-to-flare adapter fitting 3. Open the shutoff valve in the supply line. The valve is open when the handle is parallel to the gas pipe. A B CONNECT VENT 1. Using a 4˝ (10.2 cm) clamp, connect vent to exhaust outlet in dryer. If connecting to existing vent, make sure the vent is clean. The dryer vent must fit over the dryer exhaust outlet and inside the exhaust hood. Make sure the vent is secured to exhaust hood with a 4˝ (10.2 cm) clamp. 2. Move dryer into its final location. Do not crush or kink vent. 3. (On gas models) Make sure that there are no kinks in the flexible gas line. 4. Once the exhaust vent connection is made, remove the corner posts and cardboard. LEVEL DRYER Check the levelness of the dryer. Check levelness first side to side, then front to back. A. Closed valve B. Open valve 4. Test all connections by brushing on an approved noncorrosive leak-detection solution. Bubbles will show a leak. Correct any leak found. If the dryer is not level, prop up the dryer using a wood block. Use a wrench to adjust the legs up or down and check again for levelness. 2-22