Maytag MED6630H Owners Manual - Page 15
Wire Direct Wire Connection
View all Maytag MED6630H manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
5. Connect neutral ground wire and neutral wire 3-Wire Direct Wire Connection IMPORTANT: Use where local codes permit connecting cabinetground conductor to neutral wire. 3. Prepare your 3-wire cable for direct connection Connect neutral ground wire (E) and place hooked end (hook facing right) of neutral wire (white or center wire) (C) of direct wire cable under center screw of terminal block (B). Squeeze hooked ends together and tighten screw. 6. Connect ground wire Direct wire cable must have 5 ft. (1.52 m) of extra length so dryer may be moved if needed. Strip 3 1/2" (89 mm) of outer covering from end of cable. Strip insulation back 1" (25 mm). If using 3-wire cable with ground wire, cut bare wire even with outer covering. Shape wire ends into hooks. 4. Remove center screw Connect ground wire (green or bare) (F) of direct wire cable under green external ground conductor screw (A). Tighten screw. 7. Connect remaining wires Remove center terminal block screw (B). 5. Connect neutral wire Place hooked ends of remaining direct wire cable wires under outer terminal block screws (hooks facing right). Squeeze hooked ends together and tighten screws. Insert tab of terminal block cover into slot of dryer rear panel. Secure cover with hold-down screw. Now, go to "Venting Requirements." Place hooked end of neutral wire (white or center) (C) of direct wire cable under center terminal block screw (B). Squeeze hooked end together. Tighten screw. 15