Maytag MED9700SB Use and Care Guide - Page 21

3. Remove the 2 screws that hold the handle bracket to the door. 5. Remove the plug strip or label. Style 1: Remove the plug strip. ■ Use a small flat-blade screwdriver to remove the plug strip in the door opening. Slide the head of the screwdriver under the top portion of the plug strip, being certain not to scratch the dryer surface. Lift up. Repeat in the middle and at the bottom. Remove the plug strip in the door opening and insert in the opposite side. 4. Move hinge to the other side and reattach with the 4 screws removed in Step 2. 5. Move handle bracket to the other side and reattach with the 2 screws removed in Step 3. 6. Set the inner door assembly aside. Reinstalling the door 1. Check for fingerprints on the glass. Clean if necessary. 2. Place the inner door assembly into the outer door assembly. Align the hinge in the opening on the side. To fit correctly, the inside door assembly edge is completely inside the outside door assembly edge. 3. Reassemble the inner and outer door assemblies with the 6 screws. Style 2: Remove the label. ■ Peel off the label located on the opposite side of the door opening covering the hinge mounting holes. Apply the label over the original hinge holes. 4. Replace the 2 handle screws for the door handle of the door assembly. 6. Insert a screw in the second opening from the top of the hinge opening and partially tighten. Hang the door by placing the top hinge keyhole over the second screw head and tighten the screw. By putting this screw in first, the door will hang in place while you insert and tighten the remaining 4 screws. A B C A. Dryer door B. Dryer C. Insert this screw first. 7. Close the door and check that it latches securely. 21