Maytag MEDB765FC Installation Instructions - Page 12
Connect remaining wires, Connect neutral wire, Remove center screw, Attach direct wire strain relief
![]() |
View all Maytag MEDB765FC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
3-wire Power Supply Cord Connection Use where local codes permit connecting cabinet-ground conductor to neutral wire. 3. Connect remaining wires 3-wire receptacle (NEMA type 10-30R) 3-prong plug Spade terminals with upturned ends Ring terminals 1. Remove center screw B Connect remaining wires to outer terminal block screws. Tighten screws. Finally, reinsert tab of terminal block cover into slot of dryer rear panel. Secure cover with hold-down screws. Now, go to "Venting Requirements." DIRECT WIRE CONNECTION Remove center terminal block screw (B). 2. Connect neutral wire C B Direct Wire Strain Relief 1. Attach direct wire strain relief Connect neutral wire (white or center) (C) of power supply cord to center terminal block screw (B). Tighten screw. A B C Unscrew the removable conduit connector (A) and any screws from a 3/4" (19 mm) UL listed strain relief (UL marking 12
![](/manual_guide/products/maytag-mgdb765fc-installation-instructions-e7a547a/12.png)