Maytag MEDC415EW Use & Care Guide - Page 12
If you experience, Possible Causes, Solution, Dryer Results
View all Maytag MEDC415EW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
TROUBLESHOOTING First try the solutions suggested here or visit our website at www.maytag.com/product_help In Canada www.maytag.ca for assistance and to possibly avoid a service call. If you experience Possible Causes Solution Dryer Results Clothes are not drying satisfactorily or drying times are too long (cont.) Fabric softener sheets are blocking the The air outlet grille is just inside the door, behind the lint screen. grille. Check that it is not blocked by a fabric softener sheet. Use only one fabric softener sheet, and use it only once. The dryer is located in a room with temperature below 45ºF (7ºC). Proper operation of dryer cycles requires temperatures above 45ºF (7ºC). The dryer is located in a closet. Closet doors must have ventilation openings at the top and bottom of the door. The front of the dryer requires a minimum of 1" (25 mm) of airspace, and, for most installations, the rear of the dryer requires 5" (127 mm). See Installation Instructions. Cycle time is too short Automatic cycle ending early. The load may not be contacting the sensor strips. Level the dryer. Use Timed Dry for very small loads. Change the Dry Level setting on Sensor Dry/Automatic Dry cycles. Increasing or decreasing the Dry Level setting will change the amount of drying time in a cycle. Lint on load Lint screen is clogged with lint. Clean lint screen before each load. Stains on load Improper use of fabric softener. Add dryer fabric softener sheets at the beginning of the cycle. Fabric softener sheets added to a partially dried load can stain your garments. Stains on drum Loose dyes in clothes. Drum stains are caused by dyes in clothing (usually blue jeans). These will not transfer to other clothing. Loads are wrinkled The load was not removed from dryer at Use a cycle with Wrinkle Control to tumble the load without heat to the end of the cycle. avoid wrinkling. Dryer tightly packed. Dry smaller loads that can tumble freely and reduce formation of wrinkles. Odors Recent painting, staining, or varnishing Ventilate the area. When the odors or fumes are gone from the area, in the area where your dryer is located. rewash and dry the clothing. The electric dryer is being used for the The new electric heating element may have an odor. The odor will be first time. gone after the first cycle. Load too hot Laundry items were removed from the dryer before the end of the cycle. Allow Cool Down cycle to finish before removing laundry from dryer. All cycles are cooled slowly to reduce wrinkling and make it easier to handle. Items removed before Cool Down may feel very warm. A high temperature cycle was used or Temperature/Fabric control was set to high. Select a lower temperature, and use an automatic drying cycle. These cycles sense the temperature or the moisture level in the load and shut off when the load reaches the selected dryness. This reduces overdrying. 12