Maytag MEDC555DW Installation Guide - Page 9
wire Power Supply Cord Connection, wire Power Supply Cord Connection
View all Maytag MEDC555DW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
4-wire Power Supply Cord Connection IMPORTANT: A 4-wire connection is required for mobile homes and where local codes do not permit the use of 3-wire connections. A B F 5. Connect ground wire A CD E G A. 4-wire receptacle (NEMA type 14-30R) B. 4-prong plug C. Ground prong D. Neutral prong E. Spade terminals with upturned ends F. 3/4" (19 mm) UL listed strain relief G. Ring terminals 3. Prepare to connect neutral ground wire and neutral wire. F Connect ground wire (F) (green or bare) of power supply cord to external ground conductor screw (A). Tighten screw. 6. Connect remaining wires A B E Remove center terminal block screw (B). Remove neutral ground wire (E) from external ground conductor screw (A). 4. Connect neutral ground wire and neutral wire C B E Connect neutral ground wire (E) and neutral wire (white or center) (C) of power supply cord under center terminal block screw (B). Tighten screw. Connect remaining wires to outer terminal block screws. Tighten screws. Finally, reinsert tab of terminal block cover into slot of dryer rear panel. Secure cover with hold-down screw. Now, go to Venting Requirements. 3-wire Power Supply Cord Connection Use where local codes permit connecting cabinet-ground conductor to neutral wire. B D E A C GF A. 3-wire receptacle (NEMA type 10-30R) B. 3-wire plug C. Neutral prong D. Spade terminals with upturned ends E. 3/4" (19 mm) UL listed strain relief F. Ring terminals G. Neutral (white or center wire) 3. Remove center screw B Remove center terminal block screw (B). 9