Maytag MEDE200XW Installation Instructions - Page 9
Wire Power Supply, Cord Connection
UPC - 883049193083
View all Maytag MEDE200XW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
2. Attach power supply cord to strain relief 1. Prepare to connect neutral ground wire and neutral wire. E B A Put power supply cord through the strain relief. Be sure that the wire insulation on the power supply cord is inside the strain relief. The strain relief should have a tight fit with the dryer cabinet and be in a horizontal position. Do not further tighten strain relief screws at this point. If your outlet looks like this: Power supply cord 4-wire receptacle (NEMA Type 14-30R): Go to 4-Wire Power Supply Cord Connection on this page. Power supply cord 3-wire receptacle (NEMA Type 10-30R): Go to 3-Wire Power Supply Cord Connection on page 10. Remove center terminal block screw (B). Remove neutral ground wire (E) from external ground conductor screw (A). 2. Connect neutral ground wire and neutral wire. B E C 4-wire Power Supply Cord Connection IMPORTANT: A 4-wire connection is required for moble homes and where local codes do not permit the use of 3-wire connections. Connect neutral ground wire (E) and neutral wire (white or center) (C) of power supply cord under center terminal block screw (B). Tighten screw. 3. Connect ground wire 4-wire receptacle (NEMA type 14-30R) 4-prong plug Spade terminals with upturned ends Ring terminals A F Connect ground wire (F) (green or bare) of power supply cord to external ground conductor screw (A). Tighten screw. 9