Maytag MEDE300VF Use and Care Guide - Page 10
Electrical Connection - U.S.A. Only - installation
UPC - 883049135649
View all Maytag MEDE300VF manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
Power Supply Cord Electrical Connection - U.S.A. Only Direct Wire WARNING WARNING Fire Hazard Use a new UL listed 30 amp power supply cord. Use a UL listed strain relief. Disconnect power before making electrical connections. Connect neutral wire (white or center wire) to center terminal (silver). Ground wire (green or bare wire) must be connected to green ground connector. Connect remaining 2 supply wires to remaining 2 terminals (gold). Securely tighten all electrical connections. Failure to do so can result in death, fire, or electrical shock. Fire Hazard Use 10 gauge solid copper wire. Use a UL listed strain relief. Disconnect power before making electrical connections. Connect neutral wire (white or center wire) to center terminal (silver). Ground wire (green or bare wire) must be connected to green ground connector. Connect remaining 2 supply wires to remaining 2 terminals (gold). Securely tighten all electrical connections. Failure to do so can result in death, fire, or electrical shock. 1. Disconnect power. 2. Remove the hold-down screw and terminal block cover. C A. Neutral ground wire D B. External ground conductor screw C. Center, silver-colored terminal block screw B D. Terminal block cover and holddown screw A 3. Install strain relief. Style 1: Power supply cord strain relief Remove the screws from a 3/4" (1.9 cm) UL listed strain relief (UL marking on strain relief). Put the tabs of the two clamp sections into the hole below the terminal block opening so that one tab is pointing up and the other is pointing down, and hold in place. Tighten strain relief screws enough to hold the two clamp sections together. A A. Strain relief tab pointing up B. Hole below terminal block opening B C. Clamp section C D. Strain relief tab pointing down D 10