Maytag MEDE900VJ Installation Instructions - Page 5

Electric Dryer Power, Hookup - washer

Page 5 highlights

Recommended installation spacing for cabinet installation NOTE: Some models are not recommended for cabinet installation. • For cabinet installation, with a door, minimum ventilation openings in the top of the cabinet are required. 6"* (_52 mm) ( 976 (Electric or Gas) (Electric or Gas) A* 7" (178 mm) 7" (178 mm) B* 7" (178 mm) 7" (178 mm) C* 9" (229 mm) 9" (229 mm) D** 5" (127 mm) 5" (127 mm) E 32 9/16"(827 mm) 31 1/2" (800 mm) F* 1" (25 mm) 1" (25 mm) G 1" (25 mm) 1" (25 mm) H 27" (686 mm) 27" (686 mm) I 1" (25 mm) 1" (25 mm) *Required spacing **For side or bottom venting, 0" (0 mm) spacing is allowed. Recommended installation spacing for recessed or closet installation, with stacked washer and dryer The dimensions shown are for the recommended spacing. 48 in. 2 * (310 cm 2) t_ 3"* (76 ram) T 0 24 in? * + (155cm2) 1"* (25 ram) 1" --_ (25 mm) _ 27"=}_ 686 mm (25mm) Steam (Electric or Gas) Non-steam (Electric or Gas) A* 5 1/2"(140 mm) 5" (127 mm) *Required spacing NOTE: Some models are not recommended for stacked recessed or closet installation. Mobile home - Additional installation requirements This dryer is suitable for mobile home installations. The installation must conform to the Manufactured Home Construction and Safety Standard, Title 24 CFR, Part 3280 (formerly the Federal Standard for Mobile Home Construction and Safety, Title 24, HUD Part 280) or Standard CAN/CSA-Z240 MH. Mobile home installations require: All Dryers: • Metal exhaust system hardware, which is available for purchase from your dealer. • Special provisions must be made in mobile homes to introduce outside air into the dryer. The opening (such as a nearby window) should be at least twice as large as the dryer exhaust opening. ELECTRIC DRYER POWER HOOKUP Electrical Requirements It is your responsibility • To contact a qualified electrical installer. • To be sure that the electrical connection is adequate and in conformance with the National Electrical Code, ANSI/NFPA 70latest edition and all local codes and ordinances. The National Electrical Code requires a 4-wire power supply connection for homes built after 1996, dryer circuits involved in remodeling after 1996, and all mobile home installations. A copy of the above code standards can be obtained from: National Fire Protection Association, One Batterymarch Park, Quincy, MA 02269.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16

Recommended
installation spacing for cabinet
installation
NOTE:
Some models are not recommended
for cabinet
installation.
For cabinet installation, with a door, minimum ventilation
openings in the top of the cabinet are required.
(Electric or Gas)
(Electric or Gas)
A*
7" (178 mm)
7" (178 mm)
B*
7" (178 mm)
7" (178 mm)
C*
9" (229 mm)
9" (229 mm)
D**
5" (127 mm)
5" (127 mm)
E
32 9/16"(827 mm)
31 1/2" (800 mm)
F*
1" (25 mm)
1" (25 mm)
G
1" (25 mm)
1" (25 mm)
H
27" (686 mm)
27" (686 mm)
I
1" (25 mm)
1" (25 mm)
*Required
spacing
**For side or bottom
venting,
0" (0 mm) spacing
is allowed.
Recommended
installation
spacing
for
recessed
or
closet
installation,
with
stacked
washer
and
dryer
The dimensions shown are for the recommended
spacing.
48 in. 2
*
(310 cm 2)
T
t_
3"*
(76 ram)
0
24
in?
*
+
(155
cm2)
1"* (25 ram)
6"* (_52 mm)
( 976
1"
--_
_
27"=}_
(25 mm)
686
mm
(25mm)
Steam
Non-steam
(Electric or Gas)
(Electric or Gas)
A*
5 1/2"(140 mm)
5" (127 mm)
*Required
spacing
NOTE: Some models are not recommended
for stacked recessed or
closet installation.
Mobile
home
-
Additional
installation
requirements
This dryer is suitable for mobile home installations. The installation
must conform
to the Manufactured
Home Construction
and Safety
Standard, Title 24 CFR, Part 3280 (formerly the Federal Standard for
Mobile Home Construction
and Safety, Title 24, HUD Part 280) or
Standard CAN/CSA-Z240
MH.
Mobile
home
installations
require:
All Dryers:
Metal exhaust system hardware, which is available for purchase
from your dealer.
Special provisions must be made in mobile homes to introduce
outside air into the dryer. The opening (such as a nearby
window) should be at least twice as large as the dryer exhaust
opening.
ELECTRIC DRYER POWER
HOOKUP
Electrical Requirements
It
is
your responsibility
To contact
a qualified electrical installer.
To be sure that the electrical connection
is adequate and in
conformance
with the National Electrical Code, ANSI/NFPA 70-
latest edition and all local codes and ordinances.
The National Electrical Code requires a 4-wire power supply
connection
for homes built after 1996, dryer circuits involved in
remodeling after 1996, and all mobile home installations.
A copy of the above code standards
can be obtained from:
National Fire Protection Association,
One Batterymarch
Park,
Quincy, MA 02269.