Maytag MEDX5SPAW Use & Care Guide - Page 9

Cleaning the lint screen Every load cleaning The lint screen is located in the door opening of the dryer. A screen blocked by lint can increase drying time. To clean: 1. Pull the lint screen straight up. Roll lint off the screen with your fingers. Do not rinse or wash screen to remove lint. 2. Push the lint screen firmly back into place. IMPORTANT: n Do not run the dryer with the lint screen loose, damaged, blocked, or missing. Doing so can cause overheating and damage to both the dryer and fabrics. n If lint falls off the screen into the dryer during removal, check the exhaust hood and remove the lint. See "Venting Requirements." As needed cleaning Laundry detergent and fabric softener residue can build up on the lint screen. This buildup can cause longer drying times for your clothes, or cause the dryer to stop before your load is completely dry. The screen is probably clogged if lint falls off while the screen is in the dryer. Clean the lint screen with a nylon brush every 6 months, or more frequently, if it becomes clogged due to a residue buildup. To wash: 1. Roll lint off the screen with your fingers. 2. Wet both sides of lint screen with hot water. 3. Wet a nylon brush with hot water and liquid detergent. Scrub lint screen with the brush to remove residue buildup. 4. Rinse screen with hot water. 5. Thoroughly dry lint screen with a clean towel. Reinstall screen in dryer. Vacation, storage, and moving care Install and store your dryer where it will not freeze. Because some water may stay in the hoses, freezing can damage your dryer. If storing or moving your dryer during freezing weather, winterize it. Non-Use or Storage Care Operate your dryer only when you are at home. If you will be on vacation or not using your dryer for an extended period of time, you should: 1. Unplug dryer or disconnect power. 2. Clean lint screen. See "Cleaning the Lint Screen." Moving Care For power supply cord-connected dryers: 1. Unplug the power supply cord. 2. Steam models only: Shut off water faucet. 3. Steam models only: Disconnect the water inlet hose from faucet, then drain the hose. Remove the hose from the back of the dryer. Transport hose separately. 4. Make sure leveling legs are secure in dryer base. 5. Use tape to secure dryer door. For direct-wired dryers: 1. Turn off power at fuse or breaker box. 2. Disconnect wiring. 3. Steam models only: Shut off water faucet. 4. Steam models only: Disconnect the water inlet hose from faucet, then drain the hose. Transport hose separately. 5. Make sure leveling legs are secure in dryer base. 6. Use tape to secure dryer door. Reinstalling the Dryer Follow the Installation Instructions to locate, level, and connect the dryer. 9