Maytag MEDX700AG Installation Guide - Page 9
Wire Power Supply Cord Connection
View all Maytag MEDX700AG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
3. Connect ground wire 1. Remove center screw B A F Connect ground wire (F) (green or bare) of power supply cord to external ground conductor screw (A). Tighten screw. 4. Connect remaining wires Remove center terminal block screw (B). 2. Connect neutral wire B C Connect remaining wires to outer terminal block screws. Tighten screws. Finally, reinsert tab of terminal block cover into slot of dryer rear panel. Secure cover with hold-down screw. Now, go to "Venting Requirements." 3-Wire Power Supply Cord Connection IMPORTANT: Use where local codes permit connecting cabinet-ground conductor to neutral wire. Connect neutral wire (white or center) (C) of power supply cord to center terminal block screw (B). Tighten screw. 3. Connect remaining wires 3-wire receptacle (NEMA type 10-30R) 3-prong plug Connect remaining wires to outer terminal block screws. Tighten screws. Finally, reinsert tab of terminal block cover into slot of dryer rear panel. Secure cover with hold-down screw. Now, go to "Venting Requirements." Spade terminals with upturned ends Ring terminals 9