Maytag MER5875RAS Use and Care Guide - Page 10

Oven Cooking To recall the time of day when another time function is showing, press the Clock pad. Clock time cannot be changed when the oven has been programmed for Delay Cook or Delay Clean or Cook & Hold. To cancel the Clock display: If you do not want the time of day to display: Press and hold the CANCEL and Clock pads for three seconds. The time of day will disappear from the display. When the clock display is canceled, press the Clock pad to briefly display the time of day. When the clock display is canceled, after 15 minutes, the oven control will go into Standby Mode to save energy. The display will be blank and the oven light will not operate. To "wake up" the control from Standby Mode, press any touchpad. A double beep will sound. To restore the Clock display: Press and hold the CANCEL and Clock pads for three seconds. The time of day will reappear in the display. Timer The timer can be set from one minute (0:01) up to 99 hours and 59 minutes (99:59). The timer can be used independently of any other oven activity. It can also be set while another oven function is operating. The timer does not control the oven. It only controls a beeper. To set the Timer: 1. Press the Timer pad. • 0:00 and TIMER flash in the display. 2. Press the appropriate number pads until the correct time appears in the display. • The colon and TIMER will continue to flash. 3. Press Timer pad again or wait four seconds. • The colon stops flashing and the time begins counting down. • The last minute of the timer countdown will be displayed in seconds. 4. At the end of the set time, one long beep will sound and "End" will be displayed. 5. Press the Timer pad to clear the display. To cancel the Timer: 1. Press and hold the Timer pad for three seconds. OR 2. Press the Timer pad and press '0' using the number pads. Locking the Control and Oven Door The touchpad and oven door can be locked for safety, cleaning, or to prevent unwanted use. The touchpads will not function when locked. If the oven is currently in use, the touchpads and door cannot be locked. The current time of day will remain in the display when the touchpads and door are locked. To lock: Press and hold the CANCEL and Cook & Hold pads for three seconds. (Press CANCEL pad first.) • OFF appears in the display. • LOCK flashes while the door is locking. To unlock: Press and hold the CANCEL and Cook & Hold pads for three seconds. (Press CANCEL pad first.) OFF disappears from the display. Note: The touchpads and oven door cannot be locked if the oven temperature is 400° F or above. Fault Codes BAKE or LOCK may flash rapidly in the display to alert you if there is an error or a problem. If BAKE or LOCK flash in the display, press CANCEL pad. If BAKE or LOCK continue to flash, disconnect power to the appliance. Wait a few minutes, and then reconnect power. If the flashing still continues, disconnect power to the appliance and call an authorized servicer. 9