Maytag MER8875WS Installation Instructions
Maytag MER8875WS - 30" Ing Electric Range Manual
 |
UPC - 883049186894
View all Maytag MER8875WS manuals
Add to My Manuals
Save this manual to your list of manuals |
Maytag MER8875WS manual content summary:
- Maytag MER8875WS | Installation Instructions - Page 1
INSTALLATION INSTRUCTIONS 30" (76.0 CM) FREESTANDING ELECTRIC RANGES Table of Contents RANGE SAFETY 1 INSTALLATION REQUIREMENTS 2 Tools and Parts 2 Location Requirements 2 Electrical Requirements 3 INSTALLATION INSTRUCTIONS 4 Unpack Range 4 Install Anti-Tip Bracket 5 Electrical Connection - Maytag MER8875WS | Installation Instructions - Page 2
electrical installer. Location Requirements IMPORTANT: Observe all governing codes and ordinances. ■ It is the installer's responsibility to comply with installation clearances specified on the model/serial rating plate. The model/serial rating plate is located on the right-hand side of the oven - Maytag MER8875WS | Installation Instructions - Page 3
be using and follow the instructions provided for it here. ■ Range must be connected to the proper electrical voltage and frequency as specified on the model/serial number rating plate. The model/serial number rating plate is located behind the control panel or on the oven frame behind the storage - Maytag MER8875WS | Installation Instructions - Page 4
(10-50R) INSTALLATION INSTRUCTIONS Unpack Range WARNING Excessive Weight Hazard Use two or more people to move and install range. Failure to do 1. Remove shipping materials, tape and film from range. 2. Remove oven racks and parts package from inside oven. 3. Do not remove the shipping base at - Maytag MER8875WS | Installation Instructions - Page 5
Install Anti-Tip Bracket WARNING Floor Mounting A B Tip Over Hazard A child or adult can tip the range and be killed. Connect anti-tip bracket to rear range foot. Reconnect the anti-tip bracket, if the range is moved. Failure to follow these instructions can result in death or serious burns to - Maytag MER8875WS | Installation Instructions - Page 6
grounded outlet. Failure to follow these instructions can result in death, fire, or electrical shock. Electrical Shock Hazard Disconnect power before servicing. Use 8 gauge copper or 6 gauge aluminum wire. Electrically ground range. Failure to follow these instructions can result in death, fire, or - Maytag MER8875WS | Installation Instructions - Page 7
-link screw from the back of the range. Save the ground-link screw and the end of the ground link under the screw. 5. Replace back panel and screws on rear of range. 6. Complete installation following instructions for your type of electrical connection: 4-wire (recommended) 3-wire (if 4-wire is - Maytag MER8875WS | Installation Instructions - Page 8
screwdriver to connect the green ground wire from the power supply cord to the range with the ground-link screw. The ground wire must be attached first. 5. hex nuts. NOTE: For power supply cord replacement, only use a power cord rated at 250 volts minimum, 40 amps or 50 amps that is marked for use - Maytag MER8875WS | Installation Instructions - Page 9
Direct Wire Installation: Copper or Aluminum Wire This range may be connected directly to the fuse disconnect or circuit breaker box. Depending on your electrical supply, make the required 3-wire or 4-wire connection. 1. Strip outer covering back 3" (7.6 cm) to expose wires. Strip the insulation - Maytag MER8875WS | Installation Instructions - Page 10
permit connecting ground conductor to neutral supply wire. 1. Pull the conduit through the strain relief on cord/conduit plate on bottom of range. Allow enough slack to easily attach the wiring to the terminal block. A B C D E A. Terminal lug B. Set screw C. Line 1 (black) wire D. Bare (green - Maytag MER8875WS | Installation Instructions - Page 11
and oven. See the Use and Care Guide for specific instruction on range operation. If range does not operate, check the following: ■ Household fuse is intact and tight; or circuit breaker has not tripped. ■ Range is plugged into an outlet. ■ Electrical supply is connected. ■ See "Troubleshooting" in - Maytag MER8875WS | Installation Instructions - Page 12
-tip bracket is installed, use a flashlight and look underneath the bottom of the range: ■ Look for the anti-tip bracket securely attached to floor or wall. ■ Slide range back so rear range foot is under anti-tip bracket. Electrical Shock Hazard Disconnect power before servicing. Replace all parts
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
-
9
-
10
-
11
-
12
 |
 |
INSTALLATION INSTRUCTIONS
30" (76.0 CM) FREESTANDING ELECTRIC RANGES
RANGE SAFETY
Table of Contents
RANGE SAFETY
.............................................................................
1
INSTALLATION REQUIREMENTS
................................................
2
Tools and Parts
............................................................................
2
Location Requirements
................................................................
2
Electrical Requirements
...............................................................
3
INSTALLATION INSTRUCTIONS
..................................................
4
Unpack Range
..............................................................................
4
Install Anti-Tip Bracket
.................................................................
5
Electrical Connection
...................................................................
6
Verify Anti-Tip Bracket Location
................................................
11
Level Range
................................................................................
11
Complete Installation
..................................................................
11
Moving the Range
......................................................................
12
IMPORTANT:
Save for local electrical inspector's use.
W10258095A
You can be killed or seriously injured if you don't immediately
You
can be killed or seriously injured if you don't follow
All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can
happen if the instructions are not followed.
Your safety and the safety of others are very important.
We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety
messages.
This is the safety alert symbol.
This symbol alerts you to potential hazards that can kill or hurt you and others.
All safety messages will follow the safety alert symbol and either the word “DANGER” or “WARNING.”
These words mean:
follow instructions.
instructions.
DANGER
WARNING
WARNING
Tip Over Hazard
A child or adult can tip the range and be killed.
Connect anti-tip bracket to rear range foot.
Reconnect the anti-tip bracket, if the range is moved.
Failure to follow these instructions can result in death or serious burns to children and adults.