Maytag MER8875WS Installation Instructions - Page 7
wire connection: Power Supply Cord
UPC - 883049186894
View all Maytag MER8875WS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
■ Position cord/conduit plate as shown in the following illustration. B A A. Small opening B. Large opening ■ Replace cord/conduit plate and insert screws. B A A. Small opening B. Large opening ■ Assemble a UL listed conduit connector in the opening. A C B Electrical Connection Options If your home has: And you will be Go to Section: connecting to: 4-wire receptacle (NEMA type 14-50R) A UL listed, 250-volt minimum, 40-amp, range power supply cord 4-wire connection: Power supply cord 4-wire direct 5" (12.7 cm) A fused disconnect or circuit breaker box 4-wire connection: Direct wire 3-wire receptacle (NEMA type 10-50R) A UL listed, 250-volt minimum, 40-amp, range power supply cord 3-wire connection: Power supply cord 3-wire direct 1" (2.5 cm) 3" (7.6 cm) A fused disconnect or circuit breaker box 3-wire connection: Direct wire 4-wire connection: Power Supply Cord Use this method for: ■ New branch-circuit installations (1996 NEC) ■ Mobile homes ■ Recreational vehicles ■ In an area where local codes prohibit grounding through the neutral 1. Part of metal ground strap must be cut out and removed. A. Removable retaining nut - small opening B. Conduit connector C. Large opening ■ Feed the flexible conduit through the strain relief, allowing enough slack to easily attach wiring to the terminal block. ■ Tighten strain relief screw against the flexible conduit. A B C A. Metal ground strap B. Discard C. Ground-link screw 2. Use Phillips screwdriver to remove the ground-link screw from the back of the range. Save the ground-link screw and the end of the ground link under the screw. 5. Replace back panel and screws on rear of range. 6. Complete installation following instructions for your type of electrical connection: 4-wire (recommended) 3-wire (if 4-wire is not available) 7