Maytag MES5775BA Installation Instructions - Page 3

IN-'L'I - parts

Get Maytag MES5775BA - 30 in. Slide-In Electric Range PDF manuals and user guides
UPC - 719881157412
View all Maytag MES5775BA manuals
Add to My Manuals
Save this manual to your list of manuals

Page 3 highlights

IN] [0 v vhli01.=']1[LOvIAV=JIN-'L['€I 1=IdNO]-'tF,'] Ii [€ Follow these procedures to remove appliance for servicing: 1. Slide rangeforward to disengagerange from the anti-tip bracket. 2. Disconnectelectricalsupply to appliance,if equipped. 3. Reverseprocedure to reinstall. 4. To prevent range from accidentally tipping, range must be secured to the floor by sliding rear leveling leg into the anti-tip bracket. THE APPLIANCE. When your range requires service or replacement parts, contact your dealer or authorized service agency. Pleasegive the complete model and serial number of the range which is located on front frame behind storage drawer. I Your range may not be equipped with some of the features referred to in this manual. I NOTE:Figure may not be representative of actual unit. CLEARANCEDIMENSIONS Rangemay be installed with zero inches clearance adjacent to (against) combustible construction at the rear and on the sides below the cooktop. For complete information in regard to the installation of wall cabinets above the range and clearances to combustible wall abovethe cooking top see the installation drawings. For SAFETYCONSIDERATIONdSo not install a range in any combustible cabinetry which is not in accord with the installation drawings. * NOTE:30 inch (76.2 cm) dimension between cooking top and wall cabinet shown on illustration does not apply to ranges with an elevatedoven or microwave.The installation instructions of the elevatedoven will specify the minimum acceptable dimension between the cooktop and elevated oven. The 30 inch (76.2 cm) dimension may be reduced to not lessthan 24 inches (61 cm) when the wall cabinets in a domestic home are protected with fireproof materials in accordancewith American National Standards - National Fuel GasCode or in mobile homes when they are protected with fireproof materials in accordancewith the Federal Standardfor Mobile HomeConstruction and Safety. Toeliminate the risk of burns or fire by reaching over heated surface units, cabinet storage space located above the surface units should be avoided. If cabinet storage is to be provided, the risk can be reduced by installing a range hood that projects horizontally a minimum of 5 inches (13 cm) beyondthe bottom of the cabinets

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
IN
]
[0 v vl
hi01.']
=1LvA
[OIVJ
=IN-'L'I
[€1
=IN
dO]-'tF,']
I
i
[€
Follow
these
procedures
to
remove appliance for servicing:
1. Slide rangeforward
to disengage
range from
the anti-tip bracket.
2. Disconnectelectrical
supply
to appliance,
if
equipped.
3. Reverse
procedure
to reinstall.
4. To prevent range from accidentally tipping, range must be secured
to the floor by sliding rear leveling leg into the anti-tip bracket.
THE APPLIANCE.
When your range requires service or replacement parts, contact your dealer or authorized service agency. Pleasegive the complete model and serial
number of the range which is located on front frame behind storage drawer.
I Your range may not be equipped with some of the features referred to in this manual.
I
NOTE:Figuremay not be representative of actual unit.
CLEARANCEDIMENSIONS
Rangemay be installed with zero inches clearance adjacent to (against)combustible construction at the rear and on the sides below the cooktop. For
complete information in regard to the installation of wall cabinets above the range and clearances to combustible wall abovethe cooking top see the
installation drawings.For SAFETYCONSIDERATIONS
do not install a range in any combustible cabinetry which is not in accord with the installation
drawings.
*
NOTE:30 inch (76.2 cm) dimension between cooking top and wall cabinet shown on illustration does not applyto ranges with an elevatedoven or
microwave.The installation instructions of the elevated oven will specify the minimum acceptable dimension between the cooktop and elevated oven.
The 30 inch (76.2 cm) dimension may be reduced to not less than 24 inches (61 cm) when the wall cabinets in a domestic home are protected with
fireproof materials in accordancewith American National Standards - National Fuel GasCode or in mobile homes when they are protected with
fireproof materials in accordancewith the Federal Standardfor Mobile HomeConstruction and Safety.
Toeliminate the risk of burns or fire by reaching over heated surface units, cabinet storage space located above the surface units should be avoided.
If cabinet storage is to be provided, the risk can be reduced by installing a range hood that projects horizontally a minimum of 5 inches (13 cm)
beyondthe bottom of the cabinets