Maytag MES5875BAB Installation Instructions - Page 3

Followtheseproceduresto removeappliancefor servicing - parts

Page 3 highlights

Followtheseproceduresto removeappliancefor servicing: 1. Sliderangeforwardtodisengagreangefromtheanti-tipbracket. 2. Disconnecetlectricaslupplytoapplianceif,equipped. 3. Reverseprocedurteoreinstall. 4. Toprevenrtangefromaccidentaltliyppingr,angemustbesecured tothefloorbyslidingrearlevelinglegintotheanti-tipbracket. := ;t tr,'l.I]I o] ij[o] I When yourrange requires service or replacement parts, contact yourdealer or authorized service agency. Pleasegive the complete model and serial number of the range which is located on front frame behind storage drawer. I Yourrange maynot be equippedwith some of the features referred to in this manual. II NOTE:Figure may not be representative of actual unit. CLEARANCEDIMENSIONS Range may be installedwith zero inchesclearance adjacent to (against) combustible construction at the rear and on the sides below the cooktop.For completeinformationin regardto the installationof wall cabinetsabovethe rangeandclearancesto combustiblewall abovethe cookingtop see the installationdrawings.For SAFETYCONSIDERATIONdSo notinstalla rangein anycombustible cabinetry which is not in accordwith the installation drawings. * NOTE:30 inch(76.2 cm) dimension between cooking top and wall cabinet shown on illustrationdoesnot apply to ranges with an elevated oven or microwave. The installation instructions of the elevatedoven will specify the minimum acceptable dimension betweenthe cooktop and elevated oven. The 30 inch (76.2 cm) dimension may be reduced to not less than 24 inches (61 cm) when the wall cabinets in a domestic home are protected with fireproof materials in accordancewith American NationalStandards - NationalFuel GasCode or in mobile homes when they are protected with fireproof materials in accordancewith the Federal Standardfor Mobile HomeConstruction and Safety. Toeliminate the risk of burns or fire by reaching overheated surface units, cabinet storage space located above the surface units should be avoided. If cabinet storage is to be provided,the risk can be reduced by installing a range hood that projects horizontally a minimum of 5 inches (13 cm) beyond the bottom of the cabinets

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17

Followtheseproceduresto removeappliancefor servicing:
1. Slide
rangeforward
todisengage
rangefromtheanti-tipbracket.
2. Disconnect
electrical
supply
toappliance,
ifequipped.
3.Reverseprocedure
toreinstall.
4.Toprevent
rangefromaccidentally
tipping,
rangemustbesecured
tothefloorbysliding
rearleveling
legintotheanti-tipbracket.
:=
;t
tr,'.]
lI I o]
ij[o]
I
When
your
range requires service or replacement parts, contact
your
dealer
or
authorized service agency. Pleasegive
the
complete model and serial
number of the range which is located on front frame behind storage drawer.
I
Your
range maynot
be equippedwithsome
of
the
features referred
to in this
manual.
I
I
NOTE:Figure may not be representative of actual unit.
CLEARANCEDIMENSIONS
Range may be
installedwithzero inches
clearance adjacent
to
(against) combustible construction at the
rear
and
on the
sides below
the
cooktop.For
completeinformationin regardtothe installationof
wall
cabinetsabovethe rangeandclearancestocombustible
wall
abovethecookingtop
see
the
installationdrawings.ForSAFETY
CONSIDERATIONS
do notinstalla rangein any
combustible cabinetry which
is not in accord
with
the installation
drawings.
*
NOTE:30
inch
(76.2 cm) dimension between cooking
top
and
wall
cabinet shown
on illustration
doesnot apply
to
ranges
with
an elevated oven or
microwave. The installation instructions of the elevated oven will specify the minimum acceptable dimension between the cooktop and elevated oven.
The 30 inch (76.2 cm) dimension may be reduced to not less than 24 inches (61 cm) when the wall cabinets in a domestic home are protected with
fireproof materials in accordancewith American NationalStandards - NationalFuel
Gas
Code or in mobile homes when they are protected with
fireproof materials in accordancewith the Federal Standardfor Mobile HomeConstruction and Safety.
Toeliminate
the
risk
of
burns or fire by reaching
over
heated surface units, cabinet storage space located above
the
surface units should be avoided.
If cabinet storage is to be provided,the risk can be reduced by installing a range hood that projects horizontally a minimum of 5 inches (13 cm)
beyond the bottom of the cabinets