Maytag MES5875BAS Installation Instructions - Page 3

How To Remove Range For Servicing, Service-parts Information, Important: Keep For Local Inspector

Get Maytag MES5875BAS - 30 Inch Slide-In Electric Range PDF manuals and user guides
UPC - 719881153292
View all Maytag MES5875BAS manuals
Add to My Manuals
Save this manual to your list of manuals

Page 3 highlights

HOW TO REMOVE RANGE FOR SERVICING Follow these procedures to remove appliance for servicing: 1. Slide range forward to disengage range from the anti-tip bracket. 2. Disconnect electrical supply to appliance, if equipped. 3. Reverse procedure to reinstall. 4. To prevent range from accidentally tipping, range must be secured to the floor by sliding rear leveling leg into the anti-tip bracket. WARNING DISCONNECT ELECTRICAL SUPPLY BEFORE SERVICING THE APPLIANCE. SERVICE-PARTS INFORMATION When your range requires service or replacement parts, contact your dealer or authorized service agency. Please give the complete model and serial number of the range which is located on front frame behind storage drawer. Your range may not be equipped with some of the features referred to in this manual. IMPORTANT: Keep for Local Inspector WCoamll bCuasbtiinbelets/ (3133cm" ) 13" (33 cm) Max. Depth of cabinets above cooktop (415.78c"m) (736.20c"m) 3(7".6 cm) (743165.2708c"m) (623.55c"m) 3(7".6 cm) CBoumildbinugstWibalells NOTE: Figure may not be representative of actual unit. CLEARANCE DIMENSIONS Range may be installed with zero inches clearance adjacent to (against) combustible construction at the rear and on the sides below the cooktop. For complete information in regard to the installation of wall cabinets above the range and clearances to combustible wall above the cooking top see the installation drawings. For SAFETY CONSIDERATIONS do not install a range in any combustible cabinetry which is not in accord with the installation drawings. * NOTE: 30 inch (76.2 cm) dimension between cooking top and wall cabinet shown on illustration does not apply to ranges with an elevated oven or microwave. The installation instructions of the elevated oven will specify the minimum acceptable dimension between the cooktop and elevated oven. The 30 inch (76.2 cm) dimension may be reduced to not less than 24 inches (61 cm) when the wall cabinets in a domestic home are protected with fireproof materials in accordance with American National Standards - National Fuel Gas Code or in mobile homes when they are protected with fireproof materials in accordance with the Federal Standard for Mobile Home Construction and Safety. To eliminate the risk of burns or fire by reaching over heated surface units, cabinet storage space located above the surface units should be avoided. If cabinet storage is to be provided, the risk can be reduced by installing a range hood that projects horizontally a minimum of 5 inches (13 cm) beyond the bottom of the cabinets

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
Follow these procedures to remove appliance for servicing:
1. Slide range forward to disengage range from the anti-tip bracket.
2. Disconnect electrical supply to appliance, if equipped.
3. Reverse procedure to reinstall.
4. To prevent range from accidentally tipping, range must be secured
to the floor by sliding rear leveling leg into the anti-tip bracket.
HOW TO REMOVE RANGE FOR SERVICING
SERVICE-PARTS INFORMATION
When your range requires service or replacement parts, contact your dealer or authorized service agency. Please give the complete model and serial
number of the range which is located on front frame behind storage drawer.
Your range may not be equipped with some of the features referred to in this manual.
DISCONNECT ELECTRICAL SUPPLY BEFORE SERVICING
THE APPLIANCE.
WARNING
IMPORTANT: Keep for Local Inspector
CLEARANCE DIMENSIONS
Range may be installed with zero inches clearance adjacent to (against) combustible construction at the rear and on the sides below the cooktop. For
complete information in regard to the installation of wall cabinets above the range and clearances to combustible wall above the cooking top see the
installation drawings. For SAFETY CONSIDERATIONS do not install a range in any combustible cabinetry which is not in accord with the installation
drawings.
* NOTE:
30 inch (76.2 cm) dimension between cooking top and wall cabinet shown on illustration does not apply to ranges with an elevated oven or
microwave. The installation instructions of the elevated oven will specify the minimum acceptable dimension between the cooktop and elevated oven.
The 30 inch (76.2 cm) dimension may be reduced to not less than 24 inches (61 cm) when the wall cabinets in a domestic home are protected with
fireproof materials in accordance with American National Standards - National Fuel Gas Code or in mobile homes when they are protected with
fireproof materials in accordance with the Federal Standard for Mobile Home Construction and Safety.
To eliminate the risk of burns or fire by reaching over heated surface units, cabinet storage space located above the surface units should be avoided.
If cabinet storage is to be provided, the risk can be reduced by installing a range hood that projects horizontally a minimum of 5 inches (13 cm)
beyond the bottom of the cabinets
Combustible
Building Walls
Combustible
Wall Cabinets
/
13"
(33
c
m
)
M
a
x.
D
e
p
t
h
o
f
c
abinets
abo
v
e
c
oo
k
to
p
30”
30”
(76.2 cm)
(76.2 cm)
30”
(76.2 cm)
30”
30”
(76.2 cm)
(76.2 cm)
18”
(45.7 cm)
13”
(33 cm)
3”
(7.6 cm)
25”
(63.5cm)
18”
(45.7 cm)
3”
(7.6 cm)
NOTE: Figure may not be representative of actual unit.
8101p716.pdf | Imported from Cleveland on 1/17/2007