Maytag MFF2258VEM Dimension Guide - Page 1

Maytag MFF2258VEM - 22.0 cu. Ft. Refrigerator Manual

Get Maytag MFF2258VEM - 22.0 cu. Ft. Refrigerator PDF manuals and user guides
UPC - 883049159683
View all Maytag MFF2258VEM manuals
Add to My Manuals
Save this manual to your list of manuals

Page 1 highlights

French Door Refrigerator PRODUCT MODEL NUMBERS MFF2258VE Electrical: A 115 Volt, 60 Hz., AC only 15- or 20amp fused, grounded electrical supply is required. It is recommended that a separate circuit serving only your refrigerator be provided. Use an outlet that cannot be turned off by a switch. Do not use an extension cord. NOTE: Before performing any type of installation, cleaning, or removing a light bulb, turn the refrigerator to OFF. Depending on your model, turn the freezer control to the word OFF, or press the freezer down arrow touch pad until a dash (-) appears in both the freezer and refrigerator displays. Disconnect the refrigerator from the electrical source. When you are finished, reconnect the refrigerator to the electrical source and reset the temperature controls to the desired setting. Water: A cold water supply with water pressure between 35 and 120 psi (241 and 827 kPa) is required to operate the water dispenser and ice maker. IMPORTANT: The pressure of the water coming out of a reverse osmosis system going to the water inlet valve of the refrigerator needs to be between 35 and 120 psi (241 and 827 kPa). If a reverse osmosis water filtration system is connected to your cold water supply, the water pressure to the system needs to be a minimum of approximately 40 to 60 psi (276 to 414 kPa). PRODUCT DIMENSIONS B A not incl. handle C top of cabinet E incl. handle 4 1 D overall Model # MFF2258VE Depth "A" 33" Cab. Width Cab. Height Overall Height "B" "C" "D" 32-5/8" 68-1/2" 69-15/16" Depth "E" 35-1/2" LOCATION REQUIREMENTS 1/2" (1.25 cm) To ensure proper ventilation for your refrigerator, allow for 1 ⁄ 2 " (1.25 cm) space at the top and behind the refrigerator. When installing your refrigerator next to a fixed wall, leave 2-1/2" (6.3 cm) minimum on both sides to allow for the doors to swing open. If your refrigerator has an ice maker, allow extra space at the back for the water line connections. NOTE: Do not install the refrigerator near an oven, radiator, or other heat source, nor in a location where the temperature will either fall below 55°F (13°C) or rise above 110°F (43°C). 2-1/2" (6.3 cm) Because Whirlpool Corporation policy includes a continuous commitment to improve Dimensions are for planning purposes only. For complete details, see Installation our products, we reserve the right to change materials and specifications without notice. Instructions packed with product. Specifications subject to change without notice. Ref. W10175446 07-28-08

  • 1
PRODUCT MODEL NUMBERS
PRODUCT DIMENSIONS
LOCATION REQUIREMENTS
MFF2
2
58VE
Electrical:
A 115 Volt, 60 Hz., AC only 15- or
20-
amp fused, grounded electrical supply is required.
It is recommended that a separate circuit serving
only your refrigerator be provided. Use an outlet
that cannot be turned off by a switch. Do not use
an extension cord.
NOTE:
Before performing any type of installation,
cleaning, or removing a light bulb, turn the
refrigerator to OFF. Depending on your model, turn
the freezer control to the word OFF, or press the
freezer down arrow touch pad until a dash (–)
appears in both the freezer and refrigerator
displays. Disconnect the refrigerator from the
electrical source. When you are finished, reconnect
the refrigerator to the electrical source and reset
the temperature controls to the desired setting.
Water:
A cold water supply with water pressure
between 35 and 120 psi (241 and 827 kPa) is
required to operate the water dispenser and ice
maker.
IMPORTANT:
The pressure of the water coming
out of a reverse osmosis system going to the
water inlet valve of the refrigerator needs to be
between 35 and 120 psi (241 and 827 kPa).
If a reverse osmosis water filtration system is
connected to your cold water supply, the water
pressure to the system needs to be a minimum of
approximately 40 to 60 psi (276 to 414 kPa).
Because Whirlpool Corporation policy includes a continuous commitment to improve
our products, we reserve the right to change materials and specifications without notice.
Dimensions are for planning purposes only.
For complete details, see Installation
Instructions packed with product.
Specifications subject to change without notice.
Ref. W10175446
07-28-08
4
1
D
overall
C
top of
cabinet
B
not incl.
handle
incl.
handle
A
E
Model #
Depth
Cab. Width
Cab. Height
Overall Height
Depth
"A"
"B"
"C"
"D"
"E"
MFF2
2
58VE
33"
3
2
-5/8"
68-1/2"
69-15/16"
35-1/2"
To ensure proper ventilation for your refrigerator, allow for 1⁄2" (1.25 cm) space at
the top and behind the refrigerator. When installing your refrigerator next to a fixed
wall, leave 2-1/2" (6.3 cm) minimum on both sides to allow for the doors to swing
open. If your refrigerator has an ice maker, allow extra space at the back for the
water line connections.
NOTE:
Do not install the refrigerator near an oven, radiator, or other heat source,
nor in a location where the temperature will either fall below 55°F (13°C) or rise
above 110°F (43°C).
French Door Refrigerator
2-1/2" (6.3 cm)
1/2"
(1.25 cm)