Maytag MFI2570FEZ Use & Care Guide - Page 16

PERFORMANCE DATA SHEET Water Filtration System Model UKF8001AXX-200/UKF8001 Capacity 200 Gallons (757 Liters) System tested and certified by NSF International against NSF/ANSI Standard 42, 53, 401 and CSA B483.1 for the reduction of contaminants specified on the Performance Data Sheet. This system has been tested according to NSF/ANSI Standards 42, 53, 401 and CSA B483.1 for the reduction of the substances listed below. The concentration of the indicated substances in water entering the system was reduced to a concentraion less than or equal to the permissible limit for water leaving the system, as specified in NSF/ANSI Standards 42, 53, 401 and CSA B483.1. Substance Reduction Aesthetic Effects Influent Challenge Concentration Maximum Permissable Product Water Concentration Average% Reduction Chlorine Taste/Odor 2.0 mg/L ± 10% 50% reduction 97.6% Particulate Class I* At least 10,000 particles/mL 85% reduction 98.8% Contaminant Reduction Influent Challenge Concentration Maximum Permissable Product Water Concentration Average% Reduction Lead***: @ pH 6.5 / @ pH 8.5 0.150 mg/L ± 10% 0.010 mg/L 99.3% / 99.3% Mercury: @ pH 6.5 / @ pH 8.5 0.006 mg/L ± 10% 0.002 mg/L 95.1% / 95.0% Asbestos 107 to 108 fibers/L†† >99% >99% Cysts† 50,000/L min. >99.95% 99.99% Turbidity 11 NTU ± 10% 0.5 NTU 98.1% Atrazine 0.009 mg/L ± 10% 0.003 mg/L 94.4% Benzene 0.015 mg/L ± 10% 0.005 mg/L 96.6% Carbofuran 0.080 mg/L ± 10% 0.040 mg/L 86.8% Lindane 0.002 mg/L ± 10% 0.0002 mg/L 98.8% P-Dichlorobenzene 0.225 mg/L ± 10% 0.075 mg/L 99.7% Tetrachloroethylene 0.015 mg/L ± 10% 0.005 mg/L 96.0% Toxaphene 0.015 mg/L ± 10% 0.003 mg/L 93.8% Atenolol 200 ± 20% 30 ng/L >95.9% Endrin 0.006 mg/L± 10% 0.002 mg/L 96.7% Ethylbenzene 2.1 mg/L ± 10% 0.7 mg/L 99.9% o-Dichlorobenzene 1.8 mg/L± 10% 0.6 mg/L 99.9% 2,4 - D 0.210 mg/L ± 10% 0.07 mg/L 97% Carbamazepine 1400 ± 20% 200 ng/L >98.6% DEET 1400 ± 20% 200 ng/L >98.5% Linuron 140 ± 20% 20 ng/L >96.8% Meprobamate 400 ± 20% 60 ng/L 94.6% Metolachor 1400 ± 20% 200 ng/L 98.3% Trimethoprim 140 ± 20% 20 ng/L >96.4% Bisphenol A 2000 ± 20% 300 ng/L 99.4% Estrone 140 ± 20% 20 ng/L >96.7% Nonylphenol 1400 ± 20% 200 ng/L >98.9% Ibuprofen 400 ± 20% 60 ng/L 92.9% Naproxen 140 ± 20% 20 ng/L >96.3% Phenytoin 200 ± 20% 30 ng/L >94.8% Test Parameters: pH = 7.5 ± 0.5 unless otherwise noted. Flow = 0.78 gpm (2.95 Lpm). Pressure = 60 psig (413.7 kPa). Temp. = 68°F to 71.6°F (20°C to 22°C). Rated service capacity = 200 gallons (757 liters). The compounds certified under NSF 401 have been deemed as "emerging compounds/incidental contaminants." Emerging compounds/incidental contaminants are those compounds that have been detected in drinking water supplies at trace levels. While occurring at only trace levels, these compounds can affect the public acceptance/perception of drinking water quality. It is important that operational, maintenance, and filter replacement Do not use with water that is microbiologically unsafe or of unknown quality requirements be carried out for the product to perform as advertised. Property without adequate disinfection before or after the system. Systems certified for damage can occur if all instructions are not followed. cyst reduction may be used on disinfected waters that may contain filterable The disposable cartridge must be changed at least every 6 months. cysts. EPA Est. No. 10350-MN-005. Use replacement filter UKF8001, Part #EDR4RXD1/EDR4RXD1B. 2015 suggested retail price of $49.99 U.S.A./$49.95 Canada. Prices are subject to change without notice. Refer to the "Warranty" section (in the User Instructions or User Guide) for the Manufacturer's limited warranty, name and telephone number. The filter monitor system measures the amount of water that passes through the filter and alerts you when it is time to replace the filter. To learn how to Application Guidelines/Water Supply Parameters check the water filter status, see "Using the Controls" or "Water Filtration System" in the User Instructions or User Guide. After changing the water filter, flush the water system. See "Water and Ice Dispensers" or "Water Dispenser" in the User Instructions or User Guide. These contaminants are not necessarily in your water supply. While testing was Water Supply Water Pressure Water Temperature Service Flow Rate Potable City or Well 35 - 120 psi (241 - 827 kPa) 33° - 100°F (1° - 38°C) 0.78 gpm (2.95 L/min.) @ 60 psi performed under standard laboratory conditions, actual performance may vary. The product is for cold water use only. The water system must be installed in compliance with state and local laws and regulations. *Class I particle size: >0.5 to