Maytag MGC5430BDS User Guide - Page 7

Maytag MGC5430BDS - 30" Gas Cooktop Manual

Page 7 highlights

Care & Cleaning Cleaning Procedures CAUTION: ➢ Be sure appliance is off and all parts are cool before handling or cleaning. This is to avoid damage and possible burns. ➢ To prevent staining or discoloration, clean appliance after each use. ➢ If a part is removed, be sure it is correctly replaced. and soak for 30 minutes. Scrub again, rinse and dry. ❚ Do not clean in dishwasher or self-cleaning oven. cloth. Rinse and dry. Stubborn soils may be removed with a damp Scotch-Brite* pad; rub evenly with the grain. Rinse and dry. To restore luster and remove streaks, follow with Stainless Steel Magic Spray. ❚ Discoloration -- Using a damp sponge or soft cloth, wipe with Cameo Stainless Steel Cleaner*. Rinse immediately and dry. To remove streaks and restore luster, follow with Stainless Steel Magic Spray. CONTROL KNOBS ❚ Remove knobs in the OFF position by pulling up. ❚ Wash, rinse and dry. Do not use abrasive cleaning agents as they may scratch the finish. ❚ Turn on each burner to be sure the knobs have been correctly replaced. BURNER CAPS AND SEALED GAS BURNERS Removable Burner Caps ❚ Allow burner to cool. Remove burner cap and wash in soapy water with a plastic scouring pad. For stubborn soils, clean with a soap-filled, nonabrasive pad or Cooktop Cleaning Creme (Part #20000001)** and a sponge. ❚ Do not clean in dishwasher or self-cleaning oven. Sealed Gas Burner ❚ Clean frequently. Allow burner to cool. Clean with soap and plastic scouring pad. For stubborn soils, clean with a soap-filled, nonabrasive pad. ❚ Be careful not to get water into the center of the burner. ❚ Use care when cleaning the ignitor. If the ignitor is wet or damaged the surface burner will not light. ❚ To ensure even cooking performance, keep burner ports free of food soils/debris. COOKTOP - PORCELAIN ENAMEL Porcelain enamel is glass fused on metal and may crack or chip with misuse. It is acid resistant, not acid proof. All spillovers, especially acidic or sugary spillovers, should be wiped up immediately with a dry cloth. ❚ When cool, wash with soapy water, rinse and dry. ❚ Never wipe off a warm or hot surface with a damp cloth. This may cause cracking or chipping. ❚ Never use oven cleaners, abrasive or caustic cleaning agents on exterior finish of range. Before You Call For Service SURFACE BURNER FAILS TO LIGHT. ❚ Check to be sure plug is securely inserted into receptacle. ❚ Check or re-set circuit breaker. Check or replace fuse. ❚ Check power supply. ❚ Check to be sure burner is correctly rated for your kind of gas. ❚ Check to be sure burner ports or ignition ports are not clogged. ❚ Check to be sure ignitor is dry and clicking. Burner will not light if ignitor is damaged, soiled or wet. If ignitor doesn't click, turn control knob OFF. ❚ Check to be sure burner cap is correctly seated on the burner base. COOKTOP - STAINLESS STEEL (SELECT MODELS) ❚ DO NOT USE ANY CLEANING PRODUCT CONTAINING CHLORINE BLEACH. ❚ ALWAYS WIPE WITH THE GRAIN WHEN CLEANING. ❚ Daily Cleaning/Light Soil -- Wipe with one of the following - soapy water, white vinegar/water solution, Formula 409 Glass and Surface Cleaner* or a similar glass cleaner - using a sponge or soft cloth. Rinse and dry. To polish and help prevent fingerprints, follow with Stainless Steel Magic Spray (Part No. 20000008)**. ❚ Moderate/Heavy Soil -- Wipe with one of the following - Bon Ami*, Smart Cleanser*, or Soft Scrub* - using a damp sponge or soft SURFACE BURNER FLAME LIFTS OFF PORTS. ❚ Check to be sure a pan is sitting on the grate above. ❚ Contact an authorized Maytag servicer. BURNER GRATES - PORCELAIN ON CAST IRON ❚ Wash grates with warm, soapy water and a nonabrasive, plastic scrubbing pad. For stubborn soils, clean with a soap-filled, nonabrasive pad or Cooktop Cleaning Creme (Part #20000001)** and a sponge. If soil remains, reapply Cooktop Cleaning Creme, cover with a damp paper towel THE FLAME IS UNEVEN. ❚ Burner ports may be clogged. ❚ Flame may need to be adjusted. Contact an authorized Maytag servicer. SURFACE BURNER FLAME IS YELLOW IN COLOR. ❚ Contact an authorized Maytag servicer. ❚ Some yellow tips on the flame are acceptable when using LP gas. * Brand names are registered trademarks of the respective manufacturers. ** To order call 1-800-688-8408. 6

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24

6
Be sure a
pp
l
i
an
c
e
i
s o
ff
and all
p
arts are
c
ool be
f
ore handl
i
ng or
c
lean
i
ng
.
Th
i
s
i
s to a
v
o
i
d damage
and
p
oss
i
ble burns
.
To prevent staining or discoloration,
clean appliance after each use.
If a part is removed, be sure it is
correctly replaced.
Cleaning Procedures
BURNER CAPS AND SEALED
GAS BURNERS
Remo
v
able Burner Ca
p
s
Allow burner to cool. Remove burner cap
and wash in soapy water with a plastic
scouring pad. For stubborn soils, clean
with a soap-filled, nonabrasive pad or
Cooktop
Cleaning
Creme
(Part
#20000001)** and a sponge.
Do not clean in dishwasher or self-clean-
ing oven.
Sealed Gas Burner
Clean frequently. Allow burner to cool.
Clean with soap and plastic scouring pad.
For stubborn soils, clean with a soap-filled,
nonabrasive pad.
Be careful not to get water into the center
of the burner.
Use care when cleaning the ignitor. If the
ignitor is wet or damaged the surface
burner will not light.
To ensure even cooking performance, keep
burner ports free of food soils/debris.
BURNER GRATES - PORCELAIN
ON CAST IRON
Wash grates with warm, soapy water and
a nonabrasive, plastic scrubbing pad. For
stubborn soils, clean with a soap-filled,
nonabrasive pad or Cooktop Cleaning
Creme (Part #20000001)** and a sponge.
If soil remains, reapply Cooktop Cleaning
Creme, cover with a damp paper towel
and soak for 30 minutes. Scrub again,
rinse and dry.
Do not clean in dishwasher or self-clean-
ing oven.
CONTROL KNOBS
Remove knobs in the OFF position by
pulling up.
Wash, rinse and dry. Do not use abrasive
cleaning agents as they may scratch the
finish.
Turn on each burner to be sure the knobs
have been correctly replaced.
COOKTOP - PORCELAIN
ENAMEL
Porcelain enamel is glass fused on metal and
may crack or chip with misuse. It is acid
resistant, not acid proof. All spillovers, espe-
cially acidic or sugary spillovers, should be
wiped up immediately with a dry cloth.
When cool, wash with soapy water, rinse
and dry.
Never wipe off a warm or hot surface with a
damp cloth. This may cause cracking or
chipping.
Never use oven cleaners, abrasive or caus-
tic cleaning agents on exterior finish of
range.
COOKTOP - STAINLESS STEEL
(SELECT MODELS)
DO
NOT
USE
ANY
CLEANING
PROD-
UCT
CONTAINING
CHLORINE
BLEACH
.
ALWAYS
WIPE
WITH
THE
GRAIN
WHEN
CLEANING
.
Da
i
l
y
Clean
i
ng/L
i
ght So
i
l ––
Wipe with
one of the following - soapy water, white
vinegar/water solution, Formula 409 Glass
and Surface Cleaner* or a similar glass
cleaner - using a sponge or soft cloth. Rinse
and dry. To polish and help prevent finger-
prints, follow with Stainless Steel Magic
Spray (Part No. 20000008)**.
Moderate/Hea
vy
So
i
l ––
Wipe with one of
the following - Bon Ami*, Smart Cleanser*,
or Soft Scrub* - using a damp sponge or soft
CAUTION:
Care & Cleaning
*
Brand names are registered trademarks of the respective manufacturers.
** To order call 1-800-688-8408.
Before You Call
For Service
cloth. Rinse and dry. Stubborn soils may be
removed with a damp Scotch-Brite* pad;
rub evenly with the grain. Rinse and dry. To
restore luster and remove streaks, follow
with Stainless Steel Magic Spray.
D
i
s
c
olorat
i
on ––
Using a damp sponge or
soft cloth, wipe with Cameo Stainless Steel
Cleaner*. Rinse immediately and dry. To
remove streaks and restore luster, follow
with Stainless Steel Magic Spray.
SUR
F
ACE BURNER
F
AILS TO LIGHT
.
Check to be sure plug is securely inserted
into receptacle.
Check or re-set circuit breaker.
Check or
replace fuse.
Check power supply.
Check to be sure burner is correctly rated
for your kind of gas.
Check to be sure burner ports or ignition
ports are not clogged.
Check to be sure ignitor is dry and clicking.
Burner will not light if ignitor is damaged,
soiled or wet. If ignitor doesn’t click, turn
control knob OFF.
Check to be sure burner cap is correctly
seated on the burner base.
SUR
F
ACE BURNER
F
LAME LI
F
TS
O
FF
PORTS
.
Check to be sure a pan is sitting on the
grate above.
Contact an authorized Maytag servicer.
THE
F
LAME IS UNEVEN
.
Burner ports may be clogged.
Flame may need to be adjusted. Contact
an authorized Maytag servicer.
SUR
F
ACE BURNER
F
LAME IS
YELLOW IN COLOR
.
Contact an authorized Maytag servicer.
Some yellow tips on the flame are accept-
able when using LP gas.