Maytag MGD4100DW Installation Guide - Page 19
Remove door from dryer, Move the door strike, Remove inner door from outer door, Remove hinge
![]() |
View all Maytag MGD4100DW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
Reverse door swing round-shaped door - double handle 1. Remove door from dryer 3. Remove inner door from outer door IMPORTANT: If the protective film has not yet been removed from the dryer, peel the film from the dryer door before proceeding. Using a TORX T25® screwdriver, remove the 4 screws securing the door hinge to the dryer and lift up and out to remove the door. Place the door on a soft towel or other non-scratch surface. Reinstall the 4 screws in the holes. 2. Move the door strike Position the door with the inside of the door facing up. Using a Phillips screwdriver, remove the 10 screws securing the inner door to the outer door. Lift off the inner door and set aside. 4. Remove hinge and latch Latch Using a TORX T25® screwdriver, remove the 2 screws securing the door strike to the door frame of the dryer. Rotate the strike 180° and attach to the opposite side of dryer door frame, as shown. Hinge Using a TORX T25® screwdriver, remove the 3 TORX® screws securing the latch plate and latch backing plate and the 5 screws holding the hinge assembly in place. 19
![](/manual_guide/products/maytag-mgd7100dw-installation-guide-0138bc4/19.png)