Maytag MGD5630H Instruction Sheet - Page 1
Maytag MGD5630H Manual
View all Maytag MGD5630H manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1 highlights
Inlet Hose Connection Instructions for Steam Dryers Instrucciones para la conexión de la manguera de entrada para secadoras con vapor Instructions de raccordement du tuyau d'arrivée d'eau pour les sécheuses avec vapeur INSTALLATION REQUIREMENTS TOOLS AND PARTS Gather the required tools and parts before starting installation. The dryer must be connected to the cold water faucet using the new inlet hoses. Do not use old hoses. Tools needed: Parts Supplied: Pliers "Y" connector Rubber washer Parts needed: (Not supplied with dryer) 5' (1.5 m) Inlet Hose Your installation may require additional parts. To order, please contact the dealer from whom you purchased your dryer or an authorized service company. 2' (0.6 m) Inlet hose CONNECT INLET HOSES 1. Turn cold water faucet off and remove washer inlet hose. 7. Using pliers, tighten the couplings an additional two-thirds turn. 2. Remove old rubber washer from inlet hose and replace with new rubber washer provided. Inspect hoses to be sure rubber washers are in place. 3. Attach 2' (0.6 m) inlet hose to cold water faucet. Screw on coupling by hand until it is seated on faucet. NOTE: Do not overtighten. Damage to the coupling can result. 8. Attach other end of 5' (1.5 m) inlet hose to fill valve at bottom or top of dryer back panel (depending on model). Screw on coupling by hand until it is seated on fill valve connector. 4. Using pliers, tighten the couplings with an additional two-thirds turn. NOTE: Do not overtighten. Damage to the coupling can result. 5. Attach "Y" connector to the end of small hose. Screw on coupling by hand until it is seated on connector. 6. Attach dryer 5 ft (1.5 m) inlet hose ends to the "Y" connector. Attach washer cold inlet hose to other side of "Y" connector. Screw on coupling by hand until it is seated on connector. Using pliers, tighten the couplings an additional two-thirds turn. NOTE: Do not overtighten. Damage to the coupling can result. 9. Using pliers, tighten the couplings an additional two-thirds turn. NOTE: Do not overtighten. Damage to the coupling can result. 10. C heck that the water faucets are on. 11. C heck for leaks around "Y" connector, faucet, and hoses. W10701405A