Maytag MGD6200K Door Reversal Guide - Page 1
Maytag MGD6200K Manual
View all Maytag MGD6200K manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1 highlights
DRYER DOOR REVERSAL INSTRUCTIONS Tools Needed Flat-blade screwdriver Plastic putty knife Minimum 8" long TORX® T25® #2 Phillips screwdriver star driver You can change your door swing from a right-side opening to a left-side opening, if desired. The following instructions are applicable for models with a side-opening door. WARNING 3. Lift door off top screws Lift door until top screws in dryer cabinet are in large part of hinge slot. Pull door forward off screws. Set door (handle side up) on top of dryer. Remove top screws from dryer cabinet. Electrical Shock Hazard Disconnect power before removing doors. Failure to do so could result in death or electrical shock. 1. Place towel on dryer Place towel on top of dryer to avoid damaging the surface. 4. Remove screws from hinges Remove screws attaching hinges to door. 2. Remove bottom screws Open dryer door. Remove bottom screws from dryer cabinet side of hinges. Loosen (do not remove) top screws from dryer cabinet side of hinges. 5. Remove screws from door Remove screws at top, bottom, and side of door (4 screws) that hold the inner and outer door together. Holding door over towel on dryer, grasp sides of outer door and lift to separate it from inner door. Set outer door aside. NOTE: Do not pry apart with putty knife or screwdriver. Do not pull on door seal or plastic door catches. TORX and T25 are trademarks of Acument Intellectual Property, LLC. 1