Maytag MGD6200KW Owners Manual - Page 8
Parts Supplied all models, Parts Needed steam models, Parts Needed not supplied with dryer
View all Maytag MGD6200KW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
Parts Supplied (all models): Pliers or slip-joint pliers Tape measure Utility knife Tin snips (new vent installations) Leveling legs (4) (Length and appearance of legs may vary according to model) Parts package is located in dryer drum. Check that all parts are included. NOTE: Do not use leveling legs supplied with dryer if installing with a pedestal or a stack kit. Parts Needed (steam models): Caulking gun and compound (new vent installations) Adjustable wrench that opens to 1" (25 mm) or hex-head socket wrench Vent clamps Putty knife 8" (203 mm) or 10" (254 mm) Wire stripper (direct-wire pipe wrench installations) "Y" connector 2' (0.6 m) inlet hose Rubber washer 5' (1.52 m) inlet hose Parts Needed (not supplied with dryer): Additional parts may be required, depending on your installation. Check local codes. Check existing electrical supply and venting. See "Electrical Requirements" and "Venting Requirements" before purchasing parts. Mobile home installations require metal exhaust system hardware available for purchase from the dealer from whom you purchased your dryer. For further information, please refer to the Quick Start Guide for service contact information. Available Accessories: Refer to your Quick Start Guide for contact and ordering information. Pipe-joint compound resistant to propane gas 8