Maytag MGD6400TB Use and Care Guide - Page 20

When using Air Fluff • Check that coverings are securely stitched. • Shake and fluff pillows by hand periodically during the cycle. • Dry item completely. Foam rubber pillows are slow to dry. NOTE: Air Fluff is not available with Sensor Dry Cycles. OPTIONS You can customize your cycles by selecting options. DRUM LIGHT ® WRINKLE PREVENT DAMP DRY CHIME OPTIONS Drum Light On some models, select Drum light to turn on the light inside tile dryer drum. During a cycle, if Drum light is selected, the drum light turns on and will remain on until DRUM IEGHT is pressed again, the door is opened and closed, or the door is left open for 5 minutes. When the dryer is not running, the drum light will turn on when DRUM LIGHT is pressed or the dryer door is opened, and it will remain on until the dryer door has been open for 5 minutes, the dryer door is closed or DRUM LIGHT is pressed again. Press DRUM lIGHT at any time to turn the drum light ON or OFF. Wrinkle Prevent Setting The Wrinkle Prevent setting helps keep wrinkles from forming when you cannot unload the dryer promptly at the end of a cycle. During this option, the dryer stops tumbling and then tumbles again for a brief period. • Press the Wrinkle Prevent setting to get up to 120 minutes of heat-free, periodic tumbling at the end of a cycle. • Stop the Wrinkle Prevent setting at any time by pressing Wrinkle Prevent setting or opening the dryer door. • For the Wrinkle Control Cycle, the Wrinkle Prevent setting is preset to ON. ]he other Sensor Dry Cycles will retain the Wrinkle Prevent setting. For example, if you select the Wrinkle Prevent setting in the Normal cycle, the Wrinkle Prevent setting will be on the next time you select the Normal cycle. NOTE: If you do not select the Wrinkle Prevent setting, the dryer stops after cool down. Damp Dry Chime Select the [)amp Dry Chime to alert you that your clothes are approximately 80% dry. lhis is useful when you want to remove lightweight items in a mixed load to avoid overdrying or remove partially dry items that may need ironing. The Damp Dry Chime is useful when drying bedsheets/linens in a mixed load. When the signal goes off, open the door to stop the dryer, rearrange the load inside the dryer, close the door and restart the dryer to finish the drying cycle. Rearranging the load will aid in the drying process. NOTE: The Damp Dry Chime is available only with the Sensor Dry Cycles. END OF CYCLE SIGNAL End of Cycle Signal The End of Cycle Signal produces an audible sound when the drying cycle is finished. Promptly removing clothes at the end of the cycle reduces wrinkling. Press END OF CYCLE SIGNAl until the desired volume (High, I.ow or OFF) is selected. • HIG[ • LOW END OF CYCLE SIGNAL NOTE: When the Wrinkle Prevent setting is selected and the End of Cycle Signal is on, a tone sounds every 5 minutes until the clothes are removed, or the Wrinkle Prevent setting ends. CHANGING CYCLES, MODIFIERS AND OPTIONS You can change Sensor Dry and limed Cycles, Modifiers and Options anytime before pressing Start. • Three short tones sound if an unavailable combination is selected. The last selection will not be accepted. Changing Cycles after pressing Start 1. Press PAUSE/CANCEL twice. 2. Select the desired cycle and options. 3. Press START. The dryer starts at the beginning of the new cycle. NOTE: If you do not press Start within 5 minutes of selecting the cycle, the dryer automatically shuts off. 20