Maytag MGD7000XR Installation Instructions - Page 5
Location Requirements - parts
View all Maytag MGD7000XR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
Optional Equipment: (Not supplied with dryer) Refer to your Use and Care Guide for information about accessories available for your dryer. LOCATION REQUIREMENTS DRYER DIMENSIONS Front view: 27" (686 mm) 381/8" (968 mm) You will need: ■■A location allowing for proper exhaust installation. See "Venting Requirements." ■■A separate 15 or 20 amp circuit for a gas dryer or 30 amp circuit for an electric dryer. ■■If using power supply cord, a grounded electrical outlet located within 2 ft. (610 mm) of either side of dryer. See "Electrical Requirements." ■■Floor must support dryer weight of 200 lbs. (90.7 kg). Also consider weight of companion appliance. ■■Cold water faucets located within 4 ft. (1.2 m) of the water fill valves, and water pressure of 20 - 120 psi (138 - 827 kPa). You may use the water supply for your washer using the "Y" connector and short hose (if needed) which are provided. ■■Level floor with maximum slope of 1" (25 mm) under entire dryer. If slope is greater than 1" (25 mm), install Extended Dryer Feet Kit, Part Number 279810. If not level, clothes may not tumble properly and automatic sensor cycles may not operate correctly. ■■For garage installation, place dryer at least 18" (460 mm) above floor. If using a pedestal, you will need 18" (460 mm) to bottom of dryer. ■■The dryer must not be installed or stored in an area where it will be exposed to water and/or weather. IMPORTANT: Do not operate, install, or store dryer where it will be exposed to water, weather, or at temperatures below 40° F (4° C). Lower temperatures may cause dryer not to shut off at end of automatic sensor cycles, resulting in longer drying times. Installation Clearances For each arrangement, consider allowing more space for ease of installation and servicing; spacing for companion appliances and clearances for walls, doors, and floor moldings. Space must be large enough to allow door to fully open. Add spacing on all sides of dryer to reduce noise transfer. If a closet door or louvered door is installed, top and bottom air openings in door are required. Check code requirements. Some codes limit, or do not permit, installation of the dryer in garages, closets, mobile homes, or sleeping quarters. Contact your local building inspector. NOTE: No other fuel-burning appliance can be installed in the same closet as a dryer. Side view: 3/4"* (18 mm) * Approx. measurement 507/8" (1292 mm) 311/8" (790 mm) 53/4"* (146 mm) 3/4"* (18 mm) Back view: * Approx. measurement 61/4" (159 mm) 53/4"* (146 mm) Vent Water inlet 297/8"* (759 mm) 31/2"* (89 mm) Gas 3/4"* (18 mm) 143/8" (365 mm) 253/4" (654 mm) 61/8"* (156 mm) * Approx. measurement NOTE: Most installations require a minimum of 5" (127 mm) clearance behind dryer for exhaust vent with elbow. See "Venting Requirements." 5