Maytag MGD8100DW Installation Guide - Page 21
Move the door strike, Remove inner door from outer door, Remove hinge and latch, from inner door,
View all Maytag MGD8100DW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
2. Move the door strike 4. Remove hinge and latch from inner door Latch Using a TORX T25® screwdriver, remove the 2 screws securing the door strike to the door frame of the dryer. Remove the 4 screws above and below the door strike and set aside for later use. Rotate the strike 180° and attach to the opposite side of dryer door frame, as shown. 3. Remove inner door from outer door Release tab Hinge Using a TORX T25® screwdriver, remove the 3 TORX® screws securing the latch plate and the 5 screws holding the hinge assembly in place. 5. Reinstall hinge and latch on opposite sides Latch Release tab Latch Position the door with the inside of the door facing up. Using a Phillips screwdriver, remove the 13 screws securing the inner door to the outer door. Lift off the inner door and set aside. NOTE: There is a small release tab on each side of the door. If the inner and outer door do not separate easily, slide a credit card, putty knife, or similar flat object between the inner and outer doors at the locations shown to release the tab. Using a TORX T25® screwdriver, reinstall the latch plate and hinge assembly on the opposite sides from which they were removed. 21