Maytag MGDB800VQ Use and Care Guide - Page 27
Stains on load or drum
UPC - 883049140599
View all Maytag MGDB800VQ manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
Cycle time too short Excessive Weight Hazard Use two or more people to move and install dryer. Failure to do so can result in back or other injury. Is the automatic cycle ending early? The load may not be contacting the sensor strips. I.evel the dryer. Change the dryness [eve[ setting on Sensor Cycles. Increasing or decreasing the dryness [eve[ will change the amount of drying time in a cycle. Lint on load • Is the lint screen clogged? Clean lint screen. Check for air movement. Stains on load or drum • Was dryer fabric softener properly used? Add dryer fabric softener sheets at the beginning of the cycle. Fabric softener sheets added to a partially dried load can stain your garments. I)rum stains are caused by dyes in clothing (usually blue jeans). This will not transfer to other clothing. Loads are wrinkled Was the load removed from dryer at the end of the cycle? Select Custom Refresh cycle to tumble the load with water and heat to help smooth out wrinkles from a load [eft in the dryer. Was the dryer overloaded? Dry smaller loads that can tumble freely. Smaller loads yield best results with the Rapid Refresh Small I.oad cycle. Results may also vary depending on fabric type. This cycle is best for reducing wrinkles and odors from loads consisting of wrinkle-free cotton, cotton polyester blends, common knits, and synthetics. Loads are still wrinkled following Steam cycles? Make sure water is connected to the dryer. Check that water inlet hose is connected to both the faucet and dryer's water inlet valve. Check that the water supply is turned on. These cycles are best for smoothing out wrinkles and reducing odors from loads consisting of wrinkle-free cotton, cotton polyester blends, common knits, and synthetic garments. NOTE: Refer to garment care label instructions. I)ry clean only garments are not recommended. Odors Have you recently been painting, staining, or varnishing in the area where your dryer is located? If so, ventilate the area. When the odors or fumes are gone from the area, rewash and dry the clothing. Is water connected to the dryer? Check that water inlet hose is connected to both the faucet and dryer's water inlet valve. Check that the water supply is turned on. To remove odors left in garments after wearing, select the Rapid Refresh Small I_oad cycle for small loads of two to four garments. This cycle is best for reducing wrinkles and odors from loads consisting of wrinkle-free cotton, cotton polyester blends, common knits, and synthetics.