Maytag MGDE250XL Owners Manual - Page 11

Changing the Auto Cycles Default Settings IMPORTANT: Your dryness level settings can be adjusted to adapt to different installations, environmental conditions, or personal preference. This change is retained and will affect all of your Auto Cycles, not just the current cycle/load. If all your loads on all Auto Cycles are consistently not as dry as you would like, you may change the default settings to increase the default dryness level. This change will affect all of your Auto Cycles. There are 3 drying settings, which are displayed using the WET, DAMP, and COOL DOWN indicators: 1. (factory preset dryness level) - WET indicator lit. 2. (slightly drier clothes, 15% more drying time) - WET and DAMP indicators lit. 3. (much drier clothes, 30% more drying time) - WET, DAMP, and COOL DOWN indicators lit. To change the Dryness Level settings: NOTE: The Dryness Level settings cannot be changed while the dryer is running. 1. Press and hold the TEMPERATURES button for at least 6 seconds. The dryer will beep, and the current drying mode will be displayed. 2. To select a new drying setting, press the TEMPERATURES button again until the desired drying setting is shown. NOTE: While cycling through the settings, the current setting will be lit solid, but the other settings will flash. 3. Press the START/PAUSE button to save the drying setting and exit to standby mode. NOTE: To exit without saving, press the POWER/CANCEL button. 4. The drying setting you selected will become your new preset drying setting for all Auto Cycles. temperatures dryness level cycle signal 11