Maytag MGR8800F Installation Instructions - Page 18
To Convert Oven Bake Burner Propane Gas to, Natural Gas
View all Maytag MGR8800F manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
3. Apply masking tape to the end of a 9/32" (7 mm) nut driver to help hold the gas orifice spud in the nut driver while changing it. Press nut driver down onto the gas orifice spud and remove by turning it counterclockwise and lifting out. Set gas orifice spud aside. C A D B To Convert Oven Bake Burner (Propane Gas to Natural Gas) 1. Remove the oven racks. 2. Remove 2 screws at the rear of the oven bottom. 3. Lift the rear of the oven bottom up and back until the front of the panel is away from the front frame. Remove from oven and set it aside on a covered surface. A B A. Orifice spud C. Screw B. Orifice spud holder D. Spark electrode 4. Gas orifice spuds are stamped with a number on the side. Replace the Propane gas orifice spud with the correct Natural gas orifice spud. XXX A A. Stamped number Refer to the following chart for the correct Natural gas orifice spud placement. 5" (12.7 cm) WC Natural Gas Orifice Spud Chart Burner Rating 19,000 BTU (ST) 17,000 BTU (ST) 18,000 BTU 17,000 BTU 15,000 BTU 9,500 BTU 8,000 BTU 5,000 BTU 1,450 BTU Size (mm) 1.96 1.84 1.98 1.96 1.75 1.35 1.25 1.00 0.53 ID Number 196AM 184AM 198AM 196AM 175AM 135AM 125AM 100AM 053AM NOTE: Refer to the model/serial/rating plate located on the oven frame behind the top right-hand side of the oven door for proper sizing of spuds for each burner location. 5. Place Propane gas orifice spuds in plastic parts bag for future use and keep with package containing literature. 6. Replace the burner base using both screws. 7. Replace burner cap. 8. Repeat steps 1 through 7 for the remaining burners. A. Screws B. Oven bottom 4. Remove 1 screw from the bake burner. 5. Slide the front of the bake burner to the side to remove tab from front of oven. Lift the back of the bake burner off the oven orifice, and set the bake burner aside. B AA A. Screw B. Bake burner 6. Using a 3/8" (9.5 mm) nut driver or combination wrench, turn the Propane gas bake burner orifice spud counterclockwise to remove. The spud will be stamped with a "56." 7. Replace the "56" spud with a "47" spud. Install the Natural gas bake burner orifice spud, turning it clockwise until snug. IMPORTANT: Do not overtighten. A A. Orifice spud 18