Maytag MGS8800FZ Dimension Guide - Page 2

ELECTRICAL REQUIREMENTS IMPORTANT: The range must be electrically grounded in accordance with local codes and ordinances, or in the absence of local codes, with the National Electrical Code, ANSI/NFPA 70 or Canadian Electrical Code, CSA C22.1. CABINET OPENING DIMENSIONS Cabinet opening dimensions shown are for 25" (64.0 cm) countertop depth, 24" (61.0 cm) base cabinet depth and 36" (91.4 cm) countertop height. IMPORTANT: If installing a range hood or microwave hood combination above the range, follow the range hood or microwave hood combination installation instructions for dimensional clearances above the cooktop surface. Range may be installed next to combustible walls with zero clearance. NOTE: When installed in a slide-in cutout, the front of oven door may protrude beyond the base cabinet. A. 18" (45.7 cm) upper side cabinet to countertop B. 13" (33 cm) max. upper cabinet depth C. 30" (76.2 cm) min. opening width D. For minimum clearance to top of cooktop, see NOTE*. E. In U.S.A.: 30" (76.2 cm) min. opening width In Canada: 31" (78.7 cm) min. opening width F. 3" (7.6 cm) min. clearance from both sides of range to side wall or other combustible material. G. The shaded area is recommended for installation of rigid gas pipe and grounded outlet. H. 131/8" (33.3 cm) I. 711/16" (19.5 cm) J. 413/16" (12.2 cm) K. 311/16" (9.4 cm) or measurement of N, whichever is greater L. 12" (30.5 cm) M. Cabinet door or hinges should not extend into the cutout. N. Remaining counter depth should not exceed 21/4" (5.7 cm) * NOTE: 24" (61.0 cm) minimum when bottom of wood or metal cabinet is shielded by not less than 1⁄4" (0.64 cm) flame retardant millboard covered with not less than No. 28 MSG sheet steel, 0.015" (0.4 mm) stainless steel, 0.024" (0.6 mm) aluminum or 0.020" (0.5 mm) copper. 30" (76.2 cm) minimum clearance between the top of the cooking platform and the bottom of an uncovered wood or metal cabinet. If codes permit and a separate ground wire is used, it is recommended that a qualified electrical installer determine that the ground path is adequate. ■■ A 120 volt, 60 Hz., AC only, 15-amp fused, electrical circuit is required. A time-delay fuse or circuit breaker is also recommended. It is recommended that a separate circuit serving only this range be provided. ■■ Electronic ignition systems operate within wide voltage limits, but proper grounding and polarity are necessary. Check that the outlet provides 120-volt power and is correctly grounded. A F I B C E G H J D L K I Because Whirlpool Corporation includes a continuous commitment to improve our products, we reserve the right to change materials and specifications without notice. Dimensions are for planning purposes only. For complete details, see Installation Instructions packed with product. Specifications subject to change without notice. Page 2 of 2 Ref. W10665256E 05/23/2016