Maytag MGT8800FZ Installation Guide - Page 15
Natural Gas Conversion - model
View all Maytag MGT8800FZ manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
6. Position the broil burner against the roof of the oven cavity and attach with screw. A B A. Broil burner orifice hood B. Broil burner To Convert Surface Burners 1. If the burner grates are installed, remove them. 2. Remove the burner caps. 3. Using a Phillips or TORX® screwdriver, remove the burner base. A C B D LP Gas Orifice Spud Chart Burner Rating 4,000 BTU 7,000 BTU 9,100 BTU 14,000 BTU Color Blue Black Green Red Number 64L 81L 97L 114L 5. Replace the Natural gas orifice spud with the correct LP gas orifice spud. See the "LP Gas Orifice Spud Chart." 6. Replace burner base and hand tighten the screws. 7. Replace burner cap. 8. Repeat steps 1 through 7 for the remaining burners. 9. Place Natural gas orifice spuds in plastic parts bag for future use and keep with literature package. 10. Replace burner grates. 11. Complete installation. See the "Make Gas Connection" and "Electronic Ignition System" sections. Checking for proper cooktop burner flame is very important. The small inner cone should have a very distinct blue flame 1/4" to 1/2" long. The outer cone is not as distinct as the inner cone. LP gas flames have a slightly yellow tip. IMPORTANT: You may have to adjust the LO setting for each cooktop burner. See "Adjust Flame Height" in the "Electronic Ignition System" section. Natural Gas Conversion WARNING A. Burner cap B.Gas tube opening C. Burner base screws D. Burner base 4. Apply masking tape to the end of a 9/32" (7.0 mm) nut driver to help hold the Natural gas orifice spud in the nut driver while changing it. Press nut driver down onto the Natural gas orifice spud and remove by turning it counterclockwise and lifting out. Set the Natural gas orifice spud aside. A Tip Over Hazard A child or adult can tip the range and be killed. Install anti-tip bracket to floor or wall per installation instructions. Slide range back so rear range foot is engaged in the slot of the anti-tip bracket. Re-engage anti-tip bracket if range is moved. Do not operate range without anti-tip bracket installed and engaged. Failure to follow these instructions can result in death or serious burns to children and adults. A. Natural gas orifice spud Use the following chart for correct LP gas orifice spud for each burner. Refer to the model/serial/rating plate behind the control panel for proper sizing of LP gas orifice spuds for each burner location. 1. Turn manual shut-off valve to the closed position. B A C A. To range B. Shut-off valve (closed position) C. Gas supply line 2. Unplug range or disconnect power. 15