Maytag MHW3505FW Installation Guide - Page 6
Connect Drain Hose
View all Maytag MHW3505FW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
3. R emove transport bolts from washer 6. Place power cord over top Loosen bolts with a 1/2" (13 mm) wrench. Slide each bolt and spacer to center of hole. Pull bolts and plastic spacers from back of washer. Discard bolts and spacers. 4. C over bolt holes with transport bolt hole plugs Remove the yellow shipping strap from the cord. Gently place power cord over top of washer to allow free access to back of washer. IMPORTANT: Do not plug washer in until installation has been completed. CONNECT DRAIN HOSE 7. Attach drain hose to drain port Ribs Close bolt holes on cabinet back with four transport bolt hole plugs included with washer parts. 5. Remove power cord If clamp is not already in place on elbow end of drain hose, squeeze clamp with pliers and slide it over end of hose, centering it between the ribs, as shown. Squeeze clamp with pliers and slide elbow end of drain hose onto drain port and secure with clamp. For a laundry tub or standpipe drain, go to step 9. For a floor drain, remove the preinstalled drain hose form as shown in Step 8. You may need additional parts with separate directions. See "Alternate Parts". Pull power cord through opening in rear panel and close hole with attached cap. NOTE: If washer is transported at later date, call your local service center to avoid suspension and structural damage, a certified technician must properly set up washer for relocation. 6