Maytag MHW5630HC Installation Instructions - Page 5
Installation Instructions
View all Maytag MHW5630HC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
Floor drain system Floor drain system requires a Siphon Break Kit, two Connector Kits, and an Extension Drain Hose that may be purchased separately. Please contact your retailer for ordering information, or see the "Assistance or Service" page on the back of your Use and Care Guide. Minimum siphon break height: 28" (710 mm) from bottom of washer. (Additional hoses may be needed.) ELECTRICAL REQUIREMENTS INSTALLATION INSTRUCTIONS WARNING Excessive Weight Hazard Use two or more people to move and install washer. Failure to do so can result in back or other injury. NOTE: To avoid floor damage, set washer onto cardboard before moving it. 1. Move washer n A 120 V, 60 Hz., AC only, 15 or 20 A, fused electrical supply is required. A time-delay fuse or circuit breaker is recommended. It is recommended that a separate circuit breaker serving only this appliance be provided. n This washer is equipped with a power supply cord having a 3 prong grounding plug. n To minimize possible shock hazard, the cord must be plugged into a mating, 3 prong, grounding-type outlet, grounded in accordance with local codes and ordinances. If a mating outlet is not available, it is the personal responsibility and obligation of the customer to have the properly grounded outlet installed by a qualified electrician. n If codes permit and a separate ground wire is used, it is recommended that a qualified electrician determine that the ground path is adequate. n Do not ground to a gas pipe. n Check with a qualified electrician if you are not sure the washer is properly grounded. n Do not have a fuse in the neutral or ground circuit. 48" (1.2 m) It is necessary to remove all shipping materials for proper operation and to avoid excessive noise from washer. Move washer to within 4 ft. (1.2 m) of its final location. It must be in a fully upright position. 5