Maytag MHW6630HC Owners Manual 1 - Page 7
Cleaning Load & Go™ Containers (on some models), Nonuse and Vacation Care, Winter Storage Care - washer
View all Maytag MHW6630HC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
To replace: 1. Slide cover panel back onto posts on dispenser. 2. Align edges of dispenser with guides in washer; then slide dispenser back into slot. Cleaning Load & Go™ Containers (on some models) IMPORTANT: Containers are not dishwasher-safe. It is recommended that you rinse out the Load & Go™ containers when refilling, when changing detergent types or concentrations, or when the washer will not be used for an extended period. 1. Pull the dispenser drawer out until it stops. 2. Lift out the Load & Go™ containers. 3. Lift the fill lid and flush interior thoroughly with warm water. Single-Load Dispenser Drawer (on some models) To remove: 1. Pull dispenser drawer out until it stops. 2. Press down on the release tab and pull straight out to remove the dispenser. 3. Lift off cover panel by pulling straight up. To replace: 1. Position cover panel back onto posts on dispenser. Apply slight pressure on cover panel to seat it. 2. Align edges of dispenser with guides in washer; then slide dispenser back into slot. 4. Allow to air dry. Nonuse and Vacation Care Operate your washer only when you are home. If moving, or not using your washer for a period of time, follow these steps: 1. Unplug or disconnect power to washer. 2. Turn off water supply to washer to avoid flooding due to water pressure surges. HELPFUL TIP: Attach a reminder note to the washer to turn the water back on before washer's next use. 3. Clean the dispensers. See "Cleaning the Dispensers." Winter Storage Care IMPORTANT: To avoid damage, install and store washer where it will not freeze. Because some water may stay in hoses, freezing can damage washer. If storing or moving during freezing weather, winterize your washer. To winterize washer: 1. Shut off both water faucets; disconnect and drain water inlet hoses. HELPFUL TIP: Attach a reminder note to the washer to turn the water back on before washer's next use. 2. Remove drain pump filter. 3. Put 1 qt. (1 L) of R.V.-type antifreeze in drum and run washer on Normal cycle for about 2 minutes to mix antifreeze and remaining water. 4. Unplug washer or disconnect power. 7