Maytag MHWE201YW Installation Guide - Page 8

13. Connect inlet hoses to washer LEVEL WASHER Leveling your washer properly reduces excess noise and vibration. NOTE: Installing washer on soft floor surfaces, such as carpets or surfaces with foam backing, is not recommended. 16. Check levelness of washer place level here Attach hot water hose to hot water inlet valve marked with a red valve. Screw coupling by hand until it is snug. Use pliers to tighten couplings an additional two-thirds turn. Repeat with cold water inlet valve. IMPORTANT: To reduce risk of hose failure, replace the hoses every 5 years. Record hose installation or replacement dates for future reference. n Do not overtighten or use tape or sealants on the valve. Damage to the valves can result. n Periodically inspect and replace hoses if bulges, kinks, cuts, wear, or leaks are found. 14. Turn faucets on and check for leaks Remove cardboard from beneath washer. Slide washer to its final location. Place a level on top edges of washer, checking each side and front. If not level, tip washer and adjust feet up or down as shown in steps 17 and 18, repeating as necessary. If washer is against a wall, move out slightly before tipping back. Slowly turn on water faucets to check for leaks. A small amount of water may enter washer. It will drain later. 15. Secure drain hose with beaded tie strap Laundry Tub Standpipe Wall Not Level LEVEL Not Level 17. Rock washer to test foot contact 41/2" (113 mm) 41/2" (113 mm) 41/2" (113 mm) Grip washer from top and rock back and forth, making sure all four feet are firmly on floor. Repeat, rocking washer from side to side. If washer rocks, go to step 18 and adjust leveling feet. If all four feet are in firm contact with floor, go to Step 19. Secure drain hose to laundry tub leg, drain standpipe, or inlet hoses for wall standpipe with beaded tie strap located in parts bag. To avoid siphoning, do not seal or put more than 41/2" (113 mm) of the drain hose into drainpipe or standpipe. 8