Maytag MHWE301YG Use & Care Guide - Page 17
Washer not performing as expected cont.
View all Maytag MHWE301YG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
TROUBLESHOOTING First try the solutions suggested here or visit our website at www.maytag.com/help for assistance and to possibly avoid a service call. If you experience Possible Causes Solution Washer not performing as expected (cont.) Washer won't run or fill, washer stops working (cont.) Check proper electrical supply. Normal washer operation. The washer door is not firmly shut. Plug power cord into a grounded 3 prong outlet. Do not use an extension cord. Ensure there is power to outlet. Check electrical source or call an electrician to check if voltage is low. Reset a tripped circuit breaker. Replace any blown fuses. NOTE: If problems continue, contact an electrician. Door must be completely closed and latched for washer to run. Press and hold START/PAUSE for 1 second. Washer will pause during certain phases of cycle. Do not interrupt cycle. The washer pauses for about 2 minutes during certain cycles. Allow the cycle to continue. Some cycles feature periods of tumbling and soak. Washer may be stopped to reduce suds. The door must be closed during operation. Washer not loaded as recommended. Not using HE detergent or using too much HE detergent. Door not opened between cycles. Remove several items, rearrange load evenly in drum. Close door and press START/PAUSE. Do not add more than 1 or 2 additional garments after cycle has started to avoid tightly packing or unbalancing. Do not add more water to the washer. Only use HE detergent. Suds from regular detergents can slow or stop the washer. Always measure detergent and follow manufacturers directions based on your load requirements. To remove suds, cancel cycle. Select RINSE/DRAIN & SPIN. Press START/PAUSE. Do not add more detergent. After any wash cycle is completed, the door must be opened and then closed before a new cycle can begin. 17